Crestron TPS-4LW manual

Crestron TPS-4LW
9.9 · 1
PDF manual
 · 36 pages
English
manualCrestron TPS-4LW

3.6-Inch Wall Mount Touchpanel Crestron Isys

®

TPS-4L

Configuring the Touchpanel

MAIN MENU
This menu can also be obtained
via digital reserved join number,
17242.
NOTE: The only connection required to configure the touchpanel is power. Refer
to “Hardware Hookup” on page 15 for details.
NOTE: The touch screen responds to both finger and stylus commands. Since the
screen is small, Crestron recommends that a stylus (not supplied) be used to ensure
the accuracy of commands. Use a stylus that will not damage the surface of the
screen.
Prior to normal operation, it is advisable to configure the unit using a series of setup
screens. The MAIN MENU for configuring the touchpanel appears when a finger
(or stylus) is held (approximately five seconds) to the touchscreen when power is
applied or when the reset button is pressed.
Upon entering SETUP MODE, the MAIN MENU, shown to the left, displays four
buttons: Touch Screen Calibration, Exit and Run Program, Setup, and
Diagnostics.
Selecting Exit and Run Program verifies that all of the setup information has been
saved to EEPROM and displays the main page that has been programmed into the
touchpanel. The remaining buttons on the MAIN MENU open other menus, which
are discussed in subsequent paragraphs.

Calibration Menu

CALIBRATION MENU
Calibration of the touchscreen is required if the active touch area of a button does
not coincide with the button's image. Select the Touch Screen Calibration button
to display the CALIBRATION MENU, as shown to the left. The CALIBRATION
MENU offers the choice to initiate calibration with the Perform Calibration
button or return to the previous screen with the Return button. Choose an option by
touching the appropriate button.
If you need to calibrate the touchpanel, the screen displays the message "Touch
Upper Left" centered on the panel with a cross hair in the upper left corner. Touch
the cross hair to initiate calibration. Another message, "Touch Upper Right",
appears with a cross hair in the correct corner. Touch the cross hair. A final
message, “Touch Lower Right”, appears with a cross hair in the correct corner.
Touch the crosshair to finish the calibration and return to the MAIN MENU.
NOTE: When touching each crosshair during calibration, be as accurate as possible.
Use a stylus or the tip of a capped pen or the eraser end of a pencil. To cancel
calibration and return to the CALIBRATION MENU without saving calibration data,
create a calibration error by touching the screen in an area that is opposite from the
instructed area.
8 3.6-Inch Wall Mount Touchpanel: TPS-4L Operations & Installation Guide – DOC. 6449A

Manual

View the manual for the Crestron TPS-4LW here, for free. This manual comes under the category not categorized and has been rated by 1 people with an average of a 9.9. This manual is available in the following languages: English. Do you have a question about the Crestron TPS-4LW or do you need help? Ask your question here

Need help?

Do you have a question about the Crestron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Crestron TPS-4LW specifications

Below you will find the product specifications and the manual specifications of the Crestron TPS-4LW.

General
BrandCrestron
ModelTPS-4LW | TPS-4LW
Productnot categorized
LanguageEnglish
FiletypeUser manual (PDF)
Display
Display diagonal3.6 "
Display typeTFT
Display resolution320 x 240 pixels
Display brightness300 cd/m²
Touchscreen technologyResistive
Backlight typeLED
Aspect ratio4:3
Color depth16 bit
Contrast ratio300:1
Viewing angle, horizontal160 °
Viewing angle, vertical130 °
Display diagonal3.6 "
Display typeTFT
Display resolution320 x 240 pixels
Touchscreen technologyResistive
Aspect ratio4:3
Color depth16 bit
Contrast ratio300:1
Viewing angle, horizontal160 °
Viewing angle, vertical130 °
Ports & interfaces
RJ-45 ports quantity1
Ethernet LANYes
Wi-FiNo
Power
Power consumption (typical)5 W
Operational conditions
Operating relative humidity (H-H)0 - 40 %
Operating temperature (T-T)10 - 90 °C
Audio
Built-in speaker(s)Yes
Audio formats supportedWAV
Certificates
CertificationCE
Weight & dimensions
Width157.3 mm
Depth53.6 mm
Height115.2 mm
Weight430 g
Width157.3 mm
Depth53.6 mm
Height115.2 mm
Weight430 g
Performance
Mounting typeIn wall
Ethernet LANYes
Ethernet LAN data rates10, 100 Mbit/s
Cabling technology10/100Base-T(X)
Wi-FiNo
Supported network protocolsDHCP
Internal memory8 MB
RAM capacity16 MB
Product colorWhite
Housing materialPlastic
Operating relative humidity (H-H)0 - 40 %
Operating temperature (T-T)10 - 90 °C
Design
CertificationCE
Product colorWhite
Housing materialPlastic
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Crestron TPS-4LW below.

What is the weight of the Crestron TPS-4LW?

The Crestron TPS-4LW has a weight of 430 g.

What certifications does the Crestron TPS-4LW have?

The Crestron TPS-4LW has the following certifications: CE.

What is the screen size of the Crestron TPS-4LW?

The screen size of the Crestron TPS-4LW is 3.6 ".

What is the height of the Crestron TPS-4LW?

The Crestron TPS-4LW has a height of 115.2 mm.

What is the screen resolution of the display of the Crestron TPS-4LW?

The screen resolution of the Crestron TPS-4LW is 320 x 240 pixels.

What is the width of the Crestron TPS-4LW?

The Crestron TPS-4LW has a width of 157.3 mm.

What is the depth of the Crestron TPS-4LW?

The Crestron TPS-4LW has a depth of 53.6 mm.

Is the manual of the Crestron TPS-4LW available in English?

Yes, the manual of the Crestron TPS-4LW is available in English .

Is your question not listed? Ask your question here

No results