Crestron CENI-GWEXER-PWE manual

Crestron CENI-GWEXER-PWE
5.4 · 1
PDF manual
 · 34 pages
English
manualCrestron CENI-GWEXER-PWE
Best Practices DOC. 6689H Installation and Setup of Crestron RF Products 27

Referenced Procedures

RFRCON (infiNET EX and Zūm Net)
Run most procedures by entering commands on the console of a gateway. In some cases,
commands entered on a gateway need to be passed to a device.
The general form of a passed-to command is as follows:
<RFRCON rfid command
Where Rfid is the RF ID of the bridge obtained from this command:
>rep

Changing Gateway RF Channels

Gateways are shipped with the channel set to 15. It is possible that the channel changed at
some point; check and correct, if needed.
Using Crestron Toolbox, open a console to the gateway to use the following commands:
>RFCHAN ? (displays command usage)
>RFCHAN (displays current channel)
>RFCHAN 25 (sets channel to 25)
NOTE: Use the InfiNET EX Diagnostic Tool to change gateway channels.
Changing Zūm Mesh RF Channel
To change the channel used in a room, send a command to a Zūm Net Bridge.
Command examples:
<RFRCON 0d SETRFCHANNEL 20 (sets channel of bridge from 0d to 20)
<RFRCON 58 GETRFCHANNEL (gets channel of bridge 58)

Gateway Energy Scan

The gateway has a built-in utility to scan all 802.15.4 channels for RF energy. This utility has
an advantage over Wi-Spy in that it reports energy as seen by the gateway itself as
opposed to energy at the location of the Wi-Spy device.
Using Crestron Toolbox, open a console to the gateway and issue the following commands:
>ENERGYSCAN (displays command usage)
>ENERGYSCAN ALL ON 0 1 8 (good default scan for all channels)
Energy Scan prints the average and peak energy levels for all channels. Run Energy Scan
several times to sample across a longer time span. The measurements cannot distinguish
between energy from different sources, for example, Wi-Fi, 802.15.4, microwave ovens, etc.
Therefore, the levels represent the sum of all sources. Turning on and off potential interferers
such as Wi-Fi, a microwave oven, etc., allows problematic sources to be identified.

Manual

View the manual for the Crestron CENI-GWEXER-PWE here, for free. This manual comes under the category wifi repeaters and has been rated by 1 people with an average of a 5.4. This manual is available in the following languages: English. Do you have a question about the Crestron CENI-GWEXER-PWE or do you need help? Ask your question here

Need help?

Do you have a question about the Crestron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Crestron CENI-GWEXER-PWE specifications

Below you will find the product specifications and the manual specifications of the Crestron CENI-GWEXER-PWE.

General
BrandCrestron
ModelCENI-GWEXER-PWE | CENI-GWEXER-PWE
Productwifi repeater
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Weight & dimensions
Weight253 g
Dimensions (WxDxH)128 x 133 x 35 mm
Design
LED indicatorsYes
Product colorBlack
Operational conditions
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Power
Heat dissipation7 BTU/h
Power consumption (typical)2.1 W
Input voltage100-240 V
Input frequency50/60 Hz
Output current0.75 A
Output voltage24 V
Power over Ethernet (PoE)Yes
Network
Networking standardsIEEE 802.3at
Ethernet LAN data rates10, 100 Mbit/s
Ports & interfaces
Ethernet LAN (RJ-45) ports1
Management features
Reset buttonYes
Features
Antenna typeExternal
Antennas quantity1
Antenna
Transmit power range0 - 20 dBmW
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Crestron CENI-GWEXER-PWE below.

What is the weight of the Crestron CENI-GWEXER-PWE?

The Crestron CENI-GWEXER-PWE has a weight of 253 g.

What is the difference between a router and a modem?

A modem provides the internet connection via the internet provider. A router then distributes the Internet signal to the devices connected to the router.

What does the download speed on the internet depend on?

The download speed on the internet depends on the type of connection you have. If you have a 25 Mb/s connection this means that theoretically you should be able to download 25 MB per second.

Is WIFI radiation harmful?

WIFI is a radio frequency signal in the form of non-ionising radiation. This radiation cannot damage cells and tissues and is therefore not harmful to human health.

Is the manual of the Crestron CENI-GWEXER-PWE available in English?

Yes, the manual of the Crestron CENI-GWEXER-PWE is available in English .

Is your question not listed? Ask your question here

No results