Crestron CENI-GWEXER-PWE manual

Crestron CENI-GWEXER-PWE
5.4 · 1
PDF manual
 · 34 pages
English
manualCrestron CENI-GWEXER-PWE
Best Practices DOC. 6689H Installation and Setup of Crestron RF Products 23

Remoting an Antenna

If the gateway cannot be mounted with the antenna properly situated, or far enough away
from a WAP or other gateways, the antenna can be remoted. For compliance reasons,
remoting must be done with a Crestron supplied antenna and extension cable. For more
information, refer to the ANT-EXT-10
page on the Crestron website.

Channel

After installing the RF gateways, set the channel on each gateway according to the channel
map. For Crestron and third party gateways, refer to the manual supplied with the gateway
to find the channel map and specified ranges.
Problem: Zigbee
®
and Wi-Fi bands overlap.
If channels are not planned, Wi-Fi can transmit on top of the EX communications causing
significant system problems. Dimmers not responding, going into local mode etc.
Always use Zigbee channels that are in between normal Wi-Fi channels.
Zigbee channels to use are 15, 20, 25, and 26.
Zigbee channel 26 has reduced power levels but is also furthest from
Wi-Fi interference

Verifying Connectivity

After the gateways are installed and the wireless devices are associated with the gateways,
move each mobile wireless device (for example, a touch screen) to the extent of the
intended usage area to verify connectivity to the gateway. If the connection fails in the usage
area, move the gateway to a different location. If necessary, install a second gateway to
cover part of the area.
NOTE: Crestron products do not support roaming between access points. The devices are
restricted to a single gateway.

Post-installation Checks

Crestron provides a tool for documenting and analyzing a wireless installation. To access
the tool and related information, refer to the Crestron Online Help
Answer ID 4742:
Wireless, Best Practices for Setting up infiNet, Wi-Fi, and RF Touchpanels.
This tool generates log files that need to be reviewed for potential network weaknesses.
Save the log files as part of the project file for later use. The log establishes a baseline for
the installation, which could help for follow-up support or add-on business.
This is a partial list of data recorded for each gateway:
Hostname, firmware version, RF channel, and RF power
List of devices with models, firmware versions, and status
Tables for routes, neighbors, end-devices, and link debug info
Energy scan results

Manual

View the manual for the Crestron CENI-GWEXER-PWE here, for free. This manual comes under the category wifi repeaters and has been rated by 1 people with an average of a 5.4. This manual is available in the following languages: English. Do you have a question about the Crestron CENI-GWEXER-PWE or do you need help? Ask your question here

Need help?

Do you have a question about the Crestron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Crestron CENI-GWEXER-PWE specifications

Below you will find the product specifications and the manual specifications of the Crestron CENI-GWEXER-PWE.

General
BrandCrestron
ModelCENI-GWEXER-PWE | CENI-GWEXER-PWE
Productwifi repeater
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Weight & dimensions
Weight253 g
Dimensions (WxDxH)128 x 133 x 35 mm
Design
LED indicatorsYes
Product colorBlack
Operational conditions
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)10 - 90 %
Power
Heat dissipation7 BTU/h
Power consumption (typical)2.1 W
Input voltage100-240 V
Input frequency50/60 Hz
Output current0.75 A
Output voltage24 V
Power over Ethernet (PoE)Yes
Network
Networking standardsIEEE 802.3at
Ethernet LAN data rates10, 100 Mbit/s
Ports & interfaces
Ethernet LAN (RJ-45) ports1
Management features
Reset buttonYes
Features
Antenna typeExternal
Antennas quantity1
Antenna
Transmit power range0 - 20 dBmW
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Crestron CENI-GWEXER-PWE below.

What is the weight of the Crestron CENI-GWEXER-PWE?

The Crestron CENI-GWEXER-PWE has a weight of 253 g.

What is the difference between a router and a modem?

A modem provides the internet connection via the internet provider. A router then distributes the Internet signal to the devices connected to the router.

What does the download speed on the internet depend on?

The download speed on the internet depends on the type of connection you have. If you have a 25 Mb/s connection this means that theoretically you should be able to download 25 MB per second.

Is WIFI radiation harmful?

WIFI is a radio frequency signal in the form of non-ionising radiation. This radiation cannot damage cells and tissues and is therefore not harmful to human health.

Is the manual of the Crestron CENI-GWEXER-PWE available in English?

Yes, the manual of the Crestron CENI-GWEXER-PWE is available in English .

Is your question not listed? Ask your question here

No results