Crestron AMP-3210S manual

Crestron AMP-3210S
8.4 · 1
PDF manual
 · 24 pages
English
manualCrestron AMP-3210S

Commercial Power Amplifiers Crestron AMP-2210S/3210S

AMP-2210S/3210S Specifications (Continued)

SPECIFICATION DETAILS

Audio

Typical of mono amplifier

channels (Continued)

Damping Factor >100

Protection

Over current, over/under voltage, over

temperature, DC offset

Frequency Response 20 Hz to 20 kHz ±0.5 dB

THD

0.05% at 1kHz at full rated power at 4/8

Ohms, 8 Ohms bridged, or 70/100 Volts;

0.1% at 20 Hz to 20 kHz, 120 W at 8 Ohms;

0.2% at 20 Hz to 20 kHz, 210 W at 4 Ohms;

0.1% at 20 Hz to 20 kHz, 420 W at 8 Ohms

bridged;

S/N Ratio >103 dB, A-weighted

Crosstalk >70 dB @ 1kHz

Gain

23 dB with INPUT LEVEL control set at

12 o’clock nominal position

Input Sensitivity

2.22 V

rms

for rated output power with INPUT

LEVEL control set at 12 o’clock nominal

position

Input Detection Threshold 40 mV RMS @ 1 kHz

Input Level Adjustment ±10 dB from nominal

Power Requirements

Main Power 100-240 Volts AC, 50/60 Hz

Power Consumption,

AMP-2210S

62 Watts @ 8 Ohms, all channels driven at

1/8 power;

88 Watts @ 4 Ohms, all channels driven at

1/8 power;

26 Watts, all channels idle;

<1 W in standby

Power Consumption,

AMP-3210S

85 Watts @ 8 Ohms, all channels driven at

1/8 power;

126 Watts @ 4 Ohms, all channels driven

at 1/8 power;

32 Watts, all channels idle;

<1 W in standby

Environmental

Temperature 41° to 104° F (5° to 40° C)

Humidity 10% to 90% RH (non-condensing)

Heat Dissipation,

AMP-2210S

110 BTU/Hr @ 8 Ohms, all channels driven

at 1/8 power;

121 BTU/Hr @ 4 Ohms, all channels driven

at 1/8 power;

89 BTU/Hr, all channels idle;

<3.4 BTU/Hr in standby

(Continued on following page)

4 Commercial Power Amplifiers: AMP-2210S/3210S Operations & Installation Guide – DOC. 7251A

Manual

View the manual for the Crestron AMP-3210S here, for free. This manual comes under the category receivers and has been rated by 1 people with an average of a 8.4. This manual is available in the following languages: English. Do you have a question about the Crestron AMP-3210S or do you need help? Ask your question here

Need help?

Do you have a question about the Crestron and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Crestron AMP-3210S specifications

Below you will find the product specifications and the manual specifications of the Crestron AMP-3210S.

General
BrandCrestron
ModelAMP-3210S | AMP-3210S
Productreceiver
LanguageEnglish
FiletypeUser manual (PDF), Datasheet (PDF)
Audio
Audio output channels3.0 channels
Peak power per channel420 W
Amplifier class-
Total Harmonic Distortion (THD)0.05 %
Signal-to-Noise Ratio (SNR)103 dB
Damping factor100
RMS power output per channel (4 Ohm)210 W
RMS power output per channel (8 Ohm)120 W
Crosstalk (1kHz)70 dB
Input sensitivity2.22 mV
Output impedance4/8 Ω
Frequency range20 - 20000 Hz
Ports & interfaces
Speakers connectivity type3.5mm
Technical details
Purpose-
Connectivity technologyWired
Product colorBlack
Cooling typePassive
MaterialMetal, Polycarbonate
Bridge functionYes
Impedance24000 Ω
Sustainability certificatesENERGY STAR
Power
AC input voltage100-240 V
AC input frequency50 - 60 Hz
Power consumption (typical)126 W
Power consumption (standby)1 W
Weight & dimensions
Width439 mm
Depth263 mm
Height44 mm
Weight3800 g
Operational conditions
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)10 - 90 %
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Crestron AMP-3210S below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my receiver?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

What is the weight of the Crestron AMP-3210S?

The Crestron AMP-3210S has a weight of 3800 g.

What is the height of the Crestron AMP-3210S?

The Crestron AMP-3210S has a height of 44 mm.

What is the width of the Crestron AMP-3210S?

The Crestron AMP-3210S has a width of 439 mm.

What is the depth of the Crestron AMP-3210S?

The Crestron AMP-3210S has a depth of 263 mm.

Is the manual of the Crestron AMP-3210S available in English?

Yes, the manual of the Crestron AMP-3210S is available in English .

Is your question not listed? Ask your question here

No results