Your Bluetoothhandset is powered from your vessel’s 13.8 volt DC system
(12 volt nominal). A fused power connection lead is provided at the opposite
end from the bulkhead connector fitting.
1. Attach the black wire to a negative ground.
2. Attach the fused red power wire to the positive side of the vessel’s
12 volt DC power system.
Connecting (Optional) to a Stereo System AUX Input
Telephone conversations can be switched from the internal speaker in the
Bluetoothhandset to the speakers that are part of the boat’s stereo system.
1. Connect the external stereo system to the handset connector cord
with a 3.5mm male stereo jack. This cable is not supplied but can be
found at your local audio/visual store.
USB Connector
The USB connector shown next to the external stereo jack is used to
connect to a personal computer (PC) to reprogram or update the software
in the
Bluetoothhandset. The latest software and update instructions can
be found at www.cobra.com.
Connecting to the Bulkhead Connector Cord
Red
Black
1 Ampere Fuse
3.5 mm
Female Jack
USB
Male Type “A”
4
4
English
Installation
Installation
•
Before using your Bluetoothhandset, the bulkhead connector cord must be
installed on your vessel and connected to a 12 volt DC power source.
Installing the Bulkhead Connector Cord
Choose a convenient location for the connector near where the Bluetoothhandset
will be used. Keep in mind that the nine foot long coiled cord on the handset must
be attached to the connector when the handset is to be used.
1. Drill a hole through the bulkhead or dash in the chosen location 7/8 inches for a
thick dash or 5/8 inches for a thin dash.
2. Install the components as shown in the diagram.
If the dash is thin enough, the flange can be at the back surface of the dash and the
threads project out the front. If the dash is thick, the threaded part of the Male
Bulkhead Connector will project through the Mounting Plate and the hole in the dash
will be big enough for the flange at the base of the threads to be right up behind the
Mounting Plate.
Installing the Hanger Bracket
1. Install the hanger bracket on a vertical surface
near the bulkhead connector using the supplied
stainless steel screws.
Installation
I
ntroOperationCustomer
A
ssistance
W
arranty
N
otice
S
econdary Icons
C
autionWarning
Installation
C
ustomer
A
ssistance
Hanger Bracket
Installing Bulkhead Connector Cord in a Thick Dash
Bulkhead
or Dash
Male
Bulkhead
Connector
Gasket
Mounting Plate
and Screws
Nut
Dust
Cap
Installing Bulkhead Connector Cord in a Thin Dash
Bulkhead
or Dash
Male
Bulkhead
Connector
Gasket
Nut
Dust
Cap
View the manual for the Cobra MRF300 BT here, for free. This manual comes under the category Car Kits and has been rated by 1 people with an average of a 6.6. This manual is available in the following languages: English. Do you have a question about the Cobra MRF300 BT or do you need help? Ask your question here
Do you have a question about the Cobra and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Cobra owners to provide you with a good answer.
Need help?
Do you have a question about the Cobra and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Cobra owners to provide you with a good answer.
Number of questions: 0