Cateye Rapid X2 Kinetic TL-LD710K manual

Cateye Rapid X2 Kinetic TL-LD710K
6.7 · 1
PDF manual
 · 2 pages
English
manualCateye Rapid X2 Kinetic TL-LD710K
TL-LD710K
Rubber base for Sharp AeroFor posts with a more acute angle, use the rubber base for Sharp Aero. OPTIONAlways charge the product before use.Attach the light securely to the seatpost.Automatic battery-saving function:When the remaining battery power is low, the lighting mode switch starts flashing and the lighting mode changes to flash. The Kinetic function is disabled when the remaining battery power is low. Charge the light as soon as possible.
ENG
Copyright© 2017 CATEYE Co., Ltd.
TLLD710K-171117
5
HOW TO CHARGE
HOW TO USE
1
HOW TO MOUNT
2
3
1
2
1
2
SeatpostClick
Lighting mode switchPress and hold

ON OFF

Low
Approx.
5h
*
High
High
High
Flashing
Approx.
30h
*
Rapid
Approx.
16h
*
* The stated runtime of each mode exclude the Kinetic function, and the
actual runtime may vary when the Kinetic function is enabled.
*
As a reference, when the Kinetic function is enabled 60 times / hour, the
runtime will be approx. 3 hours in Low mode, approx. 7 hours in Flashing
mode, and approx. 5 hours in Rapid mode.
Kinetic function:When deceleration of the bicycle is detected, the light will turn on in the High mode for approximately 2.5 seconds regardless of the lighting mode selected. The light will remain on in the High mode as long as deceleration is detected.
WARNING!!!
• Before your trip, please make sure the light is
securely attached and lights up.
Do not use a damaged rubber band.
Always pay attention to the remaining battery power
by checking the indicator periodically while using.
CAUTION!
• This light detects deceleration through the use of
acceleration sensor. Please note that activation of
the Kinetic function depends on the degree of
deceleration, the light may not react or the
reaction may be delayed.
• Stop your bicycle to operate the switch.
• Keep the light away from children.
• Charging, discharging, and storing in high
temperatures will cause the rechargeable battery
to deteriorate faster. Do not place the light inside
a vehicle or near a heater.
This unit is not totally waterproof. Please wipe
and dry it completely after using in rain.
Otherwise, it may cause failure.
If the light unit or parts become dirty with mud,
etc., clean with a soft cloth which is moistened
with mild soap. Never apply paint thinner, benzine
or alcohol; damage will result.
PRECAUTIONS ON CHARGING
• We recommend using 500+mA (USB2.0) USB
battery charger.
Avoid charging in direct sunlight or in a vehicle
parked under direct sunlight, and make sure to
charge only when the ambient temperature is
between 5 and 40°C (41°F and 104 °F).
• Before charging, be sure that no dust or other
foreign objects attach to the USB plug.
Do not subject the light to vibrations while charging.
When your PC is in sleep state, the unit cannot be
charged.
Once charging is complete, be sure to disconnect
the USB plug.
Charging and lighting times are approximate values,
and will vary by environmental and user conditions.
• If the illumination time is significantly reduced
even after proper charging, the rechargeable
battery may be nearing the end of its service life.
Dispose of the battery as described in “PRECAU-
TIONS ON DISPOSAL”.
STORAGE PRECAUTIONS
Cool and dry storage is recommended.
For long period storage, it is important to charge the
battery 30 minutes every 6 months.
PRECAUTIONS ON DISPOSAL
When disposing of the light unit, remove the
internal rechargeable battery and dispose of it
according to local regulations.
Manual
Before using the light, read this manual thoroughly and keep it for future reference.Light unitUSB cable(MICRO USB)Rubber band (Large/Small)USB cableTo PC or USB battery chargerChargingCharging is completedStandard charging timeApprox.
2 h
(
USB 2.0
)
Switch (Indicator)Rubber band

Manual

View the manual for the Cateye Rapid X2 Kinetic TL-LD710K here, for free. This manual comes under the category Bicycle Lights and has been rated by 1 people with an average of a 6.7. This manual is available in the following languages: English. Do you have a question about the Cateye Rapid X2 Kinetic TL-LD710K or do you need help? Ask your question here

Need help?

Do you have a question about the Cateye Rapid X2 Kinetic TL-LD710K and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Cateye Rapid X2 Kinetic TL-LD710K owners to provide you with a good answer.

Damien Nagle • 12-12-2020 No comments

Hi, 18 month old Cateye rapid x2 will not recharge. Red light full beam comes on when I try to recharge. Why won't it charge?

Hi, 18 month old Cateye rapid x2 will not recharge. Red light full beam comes on when I try to recharge. 
Why won't it charge...
View photo
Answer this question

Number of questions: 1

Cateye Rapid X2 Kinetic TL-LD710K specifications

Below you will find the product specifications and the manual specifications of the Cateye Rapid X2 Kinetic TL-LD710K.

General
Brand Cateye
Model Rapid X2 Kinetic TL-LD710K
Product Bicycle Lamp
Language English
Filetype Usermanual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Cateye Rapid X2 Kinetic TL-LD710K below.

Is your question not listed? Ask your question here

No results