Casio AQ-230EGG-9AEF manual

Casio AQ-230EGG-9AEF
8.9 · 3
PDF manual
 · 2 pages
English
manualCasio AQ-230EGG-9AEF

Operation Guide 5154

E-13

Dual Time Mode

The Dual Time function lets you set a second digital time
that operates independently of the current analog and digital
times. This means you can keep track of time in another
time zone.
To set the Dual Time
In the Dual Time Mode, hold down 1. C until the hour digits
start to fl ash on the display. The hour digits fl ash because
they are selected.
Press 2. C to change the selection in the following
sequence.
12/24-Hour Format
C
C
MinutesHour
C
Dual Time Mode
SecondsHour
Minutes
Mode indicator
E-12
While the Daily Alarm/Hourly Time Signal setting is selected, press 4. B to change
the status in the following sequence.
Alarm On Indicator/Hourly Time Signal On Indicator
BBB
Both On Both Off Daily Alarm only Hourly Time
Signal only
B
After you confi gure your alarm setting, press 5. C to select the Alarm Mode.
If you do not operate any button for a few minutes while a selection is fl ashing, x
the fl ashing stops and the watch goes back to the Timekeeping Mode screen
automatically.
To test the alarm
Hold down B in any mode to sound the alarm. Note that pressing B also changes
the mode.
E-11
Press 2. C to change the selection in the following sequence.
Minutes (tens digit)
Alarm/Hourly Time Signal
C
C
Minutes (ones digit)
C
Hour
C
Alarm Mode
Once you reach the Alarm Mode screen, you have to hold down x C again to
display the fl ashing hour.
Press 3. B to increase the selected digits. Holding down B changes the selection
at high speed.
The format (12-hour or 24-hour) of the alarm time matches the format you select x
for digital timekeeping.
When setting the alarm time using the 12-hour format, take care to set the time x
correctly as a.m. (no indicator) or p.m. (PM indicator).
E-10

Alarm Mode

While the Daily Alarm function is switched on, the alarm
sounds for 20 seconds at the preset time each day. Press
any button to stop the alarm after it starts to sound. When
the Hourly Time Signal is switched on, the watch beeps
every hour on the hour. Note that the Daily Alarm and
the Hourly Time Signal operate based on the digital time
setting.
To set the alarm time
In the Alarm Mode, hold down 1. C until the hour digits
start to fl ash on the display. The hour digits fl ash
because they are selected.
Mode indicator
Hour Minutes
Alarm on indicator
Hourly Time Signal on
indicator
E-9
While the month or day digits are selected (fl ashing), press 3. B to increase the
number. While the day of the week is selected, pressing B advances to the next
day of the week. Holding down B changes the current selection at high speed.
After you set the date, press 4. C to display the Date Indicator Mode screen.
The watch does not make any allowance for leap years. Be sure to manually set x
February 29 (when one occurs) for the appropriate date.
If you do not operate any button for a few minutes while a selection is fl ashing, the x
ashing stops and the watch goes back to the Timekeeping Mode automatically.
E-8

Date Indicator Mode

To set the date
In the Date Indicator Mode, hold down 1. C until the
month digits start to fl ash on the digital display. The
month digits fl ash because they are selected.
Press 2. C to change the selection in the following
sequence.
Day
Day of the
week
C
Month
C
Date Indicator
Mode
C
Once you reach the Date Indicator Mode screen, you x
have to hold down C again to display the fl ashing
month.
Day of the weekMonth
Day
E-7
While the seconds digits are selected (fl ashing), press 3. B to reset the seconds to
“00”. If you press B while the second count is in the range of 30 to 59, it is reset to
“00” and 1 is added to the minutes. If the second count is in the range of 00 to 29,
the minute count is unchanged.
While any other digits (besides seconds) are selected (fl ashing), press 4. B to
increase the number. Holding down B changes the current selection at high
speed. While the 12/24 hour setting is selected, press B to switch between the
two formats.
After you set the time and format, press 5. C to display the Timekeeping Mode
screen.
If you do not operate any button for a few minutes while a selection is fl ashing, x
the fl ashing stops and the watch goes back to the Timekeeping Mode screen
automatically.
To set the analog time
When in any mode, press A to advance the analog time setting.
Hold down A advances the analog setting at high speed. You can only advance the
setting and cannot reverse it.
E-6

Timekeeping Mode

To set the digital time
In the Timekeeping Mode, hold down 1. C until the
seconds digits start to fl ash on the digital display.
The seconds fl ash because they are selected.
Press 2. C to change the selection in the following
sequence.
Hour
12/24-Hour Format
C
C
Minutes
C
Seconds
C
Timekeeping Mode
Once you reach the Timekeeping Mode screen, you x
have to hold down C again to display the fl ashing
seconds.
Hour hand
Minute hand
Seconds
Hour
Minutes
PM indicator
E-5

General Guide

Press x B to change from mode to mode. Each mode is explained in detail on the
following pages.
Timekeeping Mode
Date Indicator Mode Alarm Mode
Dual Time ModeStopwatch Mode
B B
B
B
B

MA1202-EA

Ú

#!3)/#/-054%2#/,4$

Manual

View the manual for the Casio AQ-230EGG-9AEF here, for free. This manual comes under the category Watches and has been rated by 3 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Casio AQ-230EGG-9AEF or do you need help? Ask your question here

Need help?

Do you have a question about the Casio AQ-230EGG-9AEF and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Casio AQ-230EGG-9AEF owners to provide you with a good answer.

Number of questions: 0

Casio AQ-230EGG-9AEF specifications

Below you will find the product specifications and the manual specifications of the Casio AQ-230EGG-9AEF.

General
Brand Casio
Model AQ-230EGG-9AEF | AQ-230EGG-9AEF
Product Watch
EAN 4549526241178
Language English
Filetype Usermanual (PDF)
Technical details
Number of time zones 2
Time zones
Stopwatch
Stopwatch accuracy 0.01 s
Alarm function
Shockproof -
Clock mode 12h/24h
Calendar
Watch type Wrist watch
Mechanism type Quartz
Chronograph -
Chronometer -
Watch dial type Analog & LCD dial
Waterproof
Calendar type Day
Design
Watch glass type Acrylic
Band material Stainless steel
Watch case material Resin
Case shape Rectangular
Band main colour Grey
Housing colour Grey
Watch dial main colour Yellow
Product design Casual
Watch marker style Non numeral
Watch marker colour Black
Gender Male
Weight & dimensions
Width 29.8 mm
Depth 8.1 mm
Height 38.8 mm
Weight 47 g
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Casio AQ-230EGG-9AEF below.

Is your question not listed? Ask your question here

No results