Turn off the projector and unplug the AC power cord. Let
the projector cool for at least 45 minutes.
Loosen the screw and open the lamp cover. Pull out the
lamp by using the built in handle.
1
3
Replace the lamp with a new one. Make sure that the
lamp is properly and fully inserted.
4
Open the filter cover. (p.57)
2
Connect the AC power cord to the projector and turn on
the projector.
6
Follow these steps to replace the lamp.
Reset the Lamp counter (p.60)
5
✔Note:
• Be sure to insert the lamp in the correct direction.
• Do not reset the Lamp counter when the projection lamp is
not replaced.
Lamp Replacement
For continued safety, replace with a lamp of the same type. Do not drop the lamp or touch the glass bulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.
CAUTION CAUTION
When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.
Top Panel
LAMP REPLACE indicator
Lamp replacement icon
✔Note:
• The Lamp replacement icon will not appear when
the Display function is set to “Off” (p.48), during
“Freeze” (p.28), or “Blank” (p.29).
7
Close the lamp cover and secure the screw.
Lamp
Handle
Lamp cover
Filter cover
Screw
Maintenance and Care
8
Close the filter cover.
Manual
View the manual for the Canon LV-7585 here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Canon LV-7585 or do you need help? Ask your question here
Need help?
Do you have a question about the Canon and is the answer not in the manual?
Question and answer
Number of questions: 0