To insure safe operation, please observe the following precautions :
●Use two (2) AAA or LR03 type alkaline batteries.
●Always replace batteries in sets.
●Do not use a new battery with a used battery.
●Avoid contact with water or liquid.
●Do not expose the remote control unit to moisture or heat.
●Do not drop the remote control unit.
●If the battery has leaked on the remote control unit, carefully
wipe the case clean and install new batteries.
●Risk of an explosion if battery is replaced by an incorrect type.
●Dispose of used batteries according to the instructions.
Point the remote control unit toward the projector (to
Infrared Remote Receivers) when pressing the buttons.
Maximum operating range for the remote control unit is
about 16.4’ (5 m) and 60 degrees in front and rear of the
projector.
Infrared Remote Receivers are provided both in front and
back of the projector. You can conveniently use both of
the receivers (pp. 10, 51).
16.4’
(5 m)
Remote Control Receivers and Operating Range
The remote control unit can be used as a wired remote control unit.
Wired remote control unit helps you use the remote control unit
outside of the operating range (16.4’/ 5 m). Connect the remote
control unit and the projector with the remote control cable (sold
separately). Connected with the remote control cable, the remote
control unit does not emit wireless signal.
Wired Remote Control Transmitter
Part Names and Functions
16.4’
(5 m)
Manual
View the manual for the Canon LV-7585 here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Canon LV-7585 or do you need help? Ask your question here
Need help?
Do you have a question about the Canon and is the answer not in the manual?
Question and answer
Number of questions: 0