The names and functions of the DR-6050C/7550C/9050C parts are shown below.
Front View, Feeder Inlet, and Eject Outlet
aUpper Unit
Open when cleaning the rollers or paper jams. (See p.3-23.)
bImprinter Cover
Open when replacing the ink cartridge in the optional
imprinter or when cleaning the imprinter. (See p. 5-13.)
cDocument Eject Tray
Scanned documents are output here. (See p. 3-10.)
dControl Panel (See p. 1-12.)
ePower Switch
Turns the scanner ON and OFF. (See p.3-2.)
fDocument Eject Tray Extension
Open the Document Eject Tray Extension when
documents look like they are going to fall off of the eject
tray. (See p. 3-10.)
gEject Paper Stoppers
Adjust to fit the length of documents, to avoid document
spillage. (See p. 3-10.)
hDocument Guides
Adjust to fit the width of documents, so that ejected
documents stack neatly. (See p. 3-10.)
iDocument Guides
Adjust to fit the width of documents. (See p. 3-8 and
p. 3-9.)
+Document Guide Lock Lever
Locks the Document Guides. (See p. 3-9.)
,Document Feed Tray
Load documents to be scanned here. (See p. 3-6.)
-Document Feeder Tray Extension / Extension Wire
Extend as needed to fit the length of the documents. (See
p. 3-7.)
CAUTION
Do not open the imprinter cover if the optional imprinter is not installed.
View the manual for the Canon imageFORMULA DR-6050C here, for free. This manual comes under the category scanners and has been rated by 2 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Canon imageFORMULA DR-6050C or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Canon imageFORMULA DR-6050C below.
Is the manual of the Canon imageFORMULA DR-6050C available in English?
Yes, the manual of the Canon imageFORMULA DR-6050C is available in English .
Need help?
Do you have a question about the Canon and is the answer not in the manual?
Question and answer
Number of questions: 1My scanner canon Dr 6050 c is showing a jam on a display. What should I do