1 When using AC power supplyPlug the provided AC power cord HT-21 to the AC power supply input terminal at the rear.•The video display goes into standby and the power indicator lights up in amber. When using DC power supply (12 V DC)Insert the DC power cord into the DC power supply input terminal at the rear.
•When connected normally, the video display goes into standby and the power indicator lights up in amber.
•DC power supply input terminal specifications are shown below.
Pin No.Signal
1- (GND)
2N.C.
3N.C.
4+ (12 V, max. 10 A)
2 Press the power supply button at the front.•The power indicator lights green.
About the power indicator
Displays the status of the main unit. The brightness of the power indicator can be set from [Off] or [1 (dark)] to [5 (brightest)] ( 105). The power indicator will flash during firmware updates or when an error is detected even if it is set to [Off].Off: when power supply is not connected Green lit: when a power supply is connected and the power of the video display is onGreen flash: during calibration or firmware updateAmber lit: during standby (a power supply is connected and the power to the video display is off)Amber flash: when error is detected
CAUTION
•Check the specifications of the DC power supply input terminal and use a power supply that is compatible with the video display.
Using a power supply with incompatible voltage and polarity may cause fire or electric shock.
•Use a DC power cord with an allowable current of at least 10 A and a length of 2 m or less. If a DC power cord longer than 2 m is
used, the video display may not work normally: for example, the video becomes choppy or nothing is displayed.
•Do not connect cables for audio devices or sound cables to the DC power supply input terminal, as it may cause damage to the
display unit.
Note
•Warming-up is necessary to stabilize the brightness of the video display. Wait at least 10 minutes after turning on the power before
using.
•When an AC power supply is connected during the use of DC power supply, the power source is switched to the AC power
supply. When this happens, the power is turned off temporarily and then turned on again.
View the manual for the Canon DP-V1711 here, for free. This manual comes under the category monitors and has been rated by 1 people with an average of a 7.2. This manual is available in the following languages: English. Do you have a question about the Canon DP-V1711 or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Canon DP-V1711 below.
What screen dimensions does my monitor have?
The size of your monitor is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your monitor, so you measure the screen from bottom left to top right.
What is HDMI?
HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.
Is the manual of the Canon DP-V1711 available in English?
Yes, the manual of the Canon DP-V1711 is available in English .
Need help?
Do you have a question about the Canon and is the answer not in the manual?
Question and answer
Number of questions: 0