Camry CR 4405B manual

Camry CR 4405B
8.8 · 1
PDF manual
 · 48 pages
English
manualCamry CR 4405B

17. Never use the appliance without water! It can cause damage.

18. Never direct a steam or hot water jet toward the body.

19. Never use carbonated water!

20. Never leave the appliance at a temperature below 0 °C as it can cause damage.

21. Before filling the water tank with water, always disconnect the appliance from the mains.

22. Before cleaning, always disconnect the espresso machine from the power supply and

wait until all hot parts have cooled. The appliance should be cleaned with a mild detergent

(without abrasives). Never use a solvent for cleaning, as this can damage the paint.

23. To decalcify the appliance, use espresso machine liquid decalcifier.

24. Never touch the filter holder or the milk frothing nozzle while the appliance is in

operation, as this may cause burns.

DESCRIPTION
1 - Cup Warmer 2 - Top Rail 3 - Water Tank Lid 4 - Water Tank
5 - Steam Knob 6 - ON/ OFF Indicating Lamp 7 - Ready Lamp 8 - Steam Lamp
9 - ON/ OFF Switch 10 - Coffee/ Hot Water Button 11 - Steam Button 12 - Filter Holder Handle
13 - Drip Water Tray 14, 15 - Base 16 - Water Outlet 17 - Milk Frothing Nozzle
18 - Coffee Measuring Spoon 19 - Ground Coffee Filter 20 - Filter Holder 21 - Coffee Outlet
22 - control lamps
BEFORE FIRST USE
After unpacking the appliance, make sure that all the buttons are off and the Steam Knob (5) is switched to the right. Before use, wipe the
appliance (please see "Cleaning and Maintenance"). Remove the Water Tank (4) and fill it up to MAX. It is recommended to use filtered
water. This prevents lime build-up and improves the taste of the prepared coffee. Do not use carbonated water. After filling the Tank (4)
with water, put it in its place. Remove the Steam Nozzle (17). Then install the Filter Holder (20) by placing it below the Water Outlet (16)
and turning it to the right. Place a cup under the installed Filter. Connect the power cord and press the ON/OFF Switch (9). The ON/ OFF
Indicating Lamp (6) will light up. After reaching adequate temperature lamp will stop blinking. Press the Coffee/ Hot Water Button (10)
immediately and wait until water starts to flow out of the filter. This means that the hydraulic system of the appliance has been filled with
water.
NOTE: If have not used your machine for a few days, it is recommended that you pass at least one cup of water through the hydraulic
system.
PREPARING CAPPUCCINO
To prepare cappuccino, you need already brewed espresso and frothed milk warmed up using steam in a separate jug (preferably made
of metal or stainless steel).
Prepare espresso (please see "Preparation"). Pour cold milk into a cooled metal jar. Make sure that the Tank (4) is filled with water. Press
the Steam Button (11). . Place a container of your choice
under the Nozzle (17) and turn the Knob (5) to the left. At the beginning, some water will
come out of the Nozzle and then a strong jet of steam will start to flow out. Turn the Knob (5) clockwise and place the metal jug filled with
milk under the Nozzle (17). Place the Nozzle in the milk and turn the Knob (5) counterclockwise. Coming out of the Nozzle, the steam will
start to froth and warm the milk in the jug. While milk is being frothed, rotate the jug around the Nozzle. To avoid hot milk splashing, never
remove the Nozzle from the milk unless the Knob (5) is turned to the right. In order to avoid heating the jug with milk, make sure that the
Nozzle does not directly touch its bottom or sides. The milk should be frothed on the surface and right under it. If steam does not come
out, the Nozzle may be clogged. When the milk is sufficiently frothed and warmed up, press the Steam Button (11) to complete the
operation. Set the jug with the frothed milk aside for a moment. Then pour the milk into your cup of espresso. After use, press the ON/
OFF Switch (9) and disconnect the appliance from the power supply. If the interval between twice operations is more than 25 minutes, the
appliance will shut off automatically.
: a - 30 ml; b - 60 ml
HEATING THE ESPRESSO MACHINE
It is important to heat the appliance so that the brewed coffee would have the right temperature. Make sure that the Steam Knob (5) is
closed and there is water in the tank (4). Place the jug under the Steam Nozzle (17). Insert the Filter (19) into the Filter Holder handle (20)
and place it under the Water Outlet (16). If you want the cups to be heated, place them on the Cup Warmer (1). Turn on the machine (9).
Lamp (7) will blink. After reaching adequate temperature lamp will stop blinking. Place the cups on the Tray (13) and press the Coffee/ Hot
Water Button (10). Wait until two cups of water flow out. Push ten button (11). Indicating Lamp (8) will light up. After reaching adequate
temperature lamp will stop blinking. Turn the Steam Knob (5) to the left and wait until a small amount of water flows into the cup. Close the
Steam Knob (5) and switch all buttons off.
PREPARING ESPRESSO
The machine is used for preparing espresso. All other beverages (e.g. café latte, latte macchiato are cappuccino) are espresso-based.
Measure the appropriate amount of coffee and place it in the filter (19). To prepare espresso, use one coffee measuring spoon (18). Make
sure that the coffee has been ground properly. Then place the Filter with the coffee inside in the Filter Holder (20). Place the Filter Holder
in the machine, turning it approximately 45 degrees to the right. Fill the Water Tank (4) with cold water. Connect the appliance to a mains
socket. NOTE: Remember that the device requires grounding. Turn on the machine (9). Lamp (7) will blink. After reaching adequate
temperature lamp will stop blinking. Press the Coffee Button (10). The brewed coffee will start to flow down through the Coffee Outlet (21).
To stop brewing, press the Coffee Button again (10). To remove the Filter Holder (20), turn it to the left. To facilitate Filter Holder removal,
turn the Knob (5) counter-clockwise to release the pressure.
NOTE: Never remove the Filter Holder (20) during brewing, that is, when the Coffee Button is on (10). After use, press the ON/ OFF
Switch (9) and disconnect the appliance from the power supply.
Lamp (8) will blink. After reaching adequate temperature lamp will stop blinking.
Never use the Knob (5) while the Lamp (8) is off.
4

Manual

View the manual for the Camry CR 4405B here, for free. This manual comes under the category coffee makers and has been rated by 1 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the Camry CR 4405B or do you need help? Ask your question here

Need help?

Do you have a question about the Camry and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Camry CR 4405B specifications

Below you will find the product specifications and the manual specifications of the Camry CR 4405B.

General
BrandCamry
ModelCR 4405B | CR 4405B
Productcoffee maker
EAN5908256837256
LanguageEnglish
FiletypeUser manual (PDF)
Performance
Appliance placementCountertop
Product typeEspresso machine
Number of spouts1
Steam pipeYes
Reservoir for brewed coffee-
Capacity in cups- cups
Water tank capacity0.15 L
Coffee input typeGround coffee
Hot water systemYes
Coffee maker typeManual
Built-in grinderNo
Maximum operating pressure15 bar
CertificationCE
Cup warmerYes
Ergonomics
Product colorBlack, Grey
Housing materialMetal, Plastic
Control typeButtons, Rotary
Built-in displayNo
CordlessNo
Removable drip trayYes
Indication lightYes
Illuminated on/off switchYes
Removable water tankYes
Detachable filter holderYes
Coffee filterYes
Cooking functions & programs
Coffee makingYes
Ristretto making-
Espresso making-
Americano making-
Cappuccino makingYes
Latte making-
Espresso Macchiato making-
Latte Macchiato making-
Mocha making-
Lungo making-
Caffe Crema making-
Hot milk making-
Tea making-
Hot chocolate making-
Chocolate milk making-
Orzo making-
Flat White making-
Multi beverageYes
Power
Power850 W
AC input voltage230 V
AC input frequency50 Hz
Other features
Steam functionYes
Packaging content
ManualYes
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Camry CR 4405B below.

What certifications does the Camry CR 4405B have?

The Camry CR 4405B has the following certifications: CE.

How often should I descale my coffee maker?

How often a coffee machine needs to be descaled depends on how often it is used and the hardness of the water. If hard water is used it is recommended to descale once a month, if soft water is used once a quarter is sufficient.

What is the best way to descale my coffee maker?

To descale the coffee maker, it is recommended to use a liquid descaling agent which is labelled as suitable for coffee machines.

What is espresso?

Espresso is a small amount of concentrated coffee.

How long can I keep coffee beans?

The best-before date can be found on the packaging of the coffee beans. This best-before date applies as long as the bag is closed.

What is the best way to store coffee?

It is recommended to store coffee in an airtight and clean container.

What does the grind say about the taste of the coffee?

How the coffee beans are ground strongly influences the taste of the coffee. If the coffee beans are very finely ground you will have a stronger taste and if the grind is coarser you will have a milder taste.

Is the manual of the Camry CR 4405B available in English?

Yes, the manual of the Camry CR 4405B is available in English .

Is your question not listed? Ask your question here

No results