Bretford PowerSync H3635 manual

Bretford PowerSync H3635
7.5 · 1
PDF manual
 · 2 pages
English
manualBretford PowerSync H3635

ELECTRICAL

Avoid sparks. Avoid arcing. Always turn OFF the power to the
cart before plugging IN or OUT!
Be sure each device is turned OFF before plugging into the cart.
For Safety Purposes, make sure all electrical components do not
exceed the the maximum load rating of 12 amps.
Risk of electrical shock. Do not plug the power cord into another
extension cord or relocatable power tap.
The Power Module inside the cart are only for charging & syncing
Apple iPad devices, only.
Do not unplug this product from the outlet when your hands are wet.
Do not move the cart by pulling the power cord.
Do not plug the unit in if the switch, receptacle(s) or power cord has
been damaged.
Contact Bretford or a qualified electrician before attempting to make
any type of electrical repair or parts replacement.
Before moving this cart from one room to the next, wrap the power
cord around the cord winder located on the side of the cart.

CAUTION

Ventilation is critical for PowerSync carts to operate correctly,
providing the appropriate airflow so that heat-buildup is minimized
during the battery-charging / syncing process.
Do Not block the ventilation holes on the cart. Proper air flow is
required for safe operation of equipment.
Cart with iPad devices should be keep in a room with a maximum
temperature not to exceed 104° F or 40° C.
Maximum weight of accessories on top of cabinet is 25 pounds. Do
not block ventilation holes when charging batteries.
Avoid loading equipment in the cart in a uneven fashion. Uneven
weight distribution could cause a hazardous condition.
This cart is not designed to be operated by a child or student. Adult
operation and supervision is recommended at all times.
Move cart slowly.
No TV/Monitor to be used on top of cart.
Although this cart is designed to support the transport of equipment
within a school campus, it is not designed for outdoor use.
Liquids should not be stored in, set on or placed inside this unit.
Do not pull cart. Push the cart using the ergonomic handles.
Engage locking casters when cart is not in transit.
Use extra caution on ramps and thresholds.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference.
2 This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
11000 Seymour Avenue Franklin Park, IL 60131 USA 800 521 9614
bretford.com/apple
OPEN
30-pin Connector
Cables Pre-Installed
hang directly in the slot &
minimize cable clutter
12 Year Warranty
on the Cabinet
2 Year Warranty
on Electrical
Ships 100%
Assembled
LED Lights
on the top and back
of the cart let you
know what is going
on inside the cart
Directional
Locking Casters
can be locked as a
rigid caster for easy
rolling down the
hallway, unlocked to
swivel for easily getting
into tight spaces
Security
Front doors 3-point
locking system with
programmable
combination padlock
Ventilation
Channels allow
maximum air
flow in the cart
Compact Design
Although this cart can store & power
up to 30 iPad devices, the exclusive
quiet-glide casters and compact size
make it very easy to move around
Auxiliary Outlet
for Host computer
inside the top
grommet
One Power Cord
Exits the cart & plugs
into the wall outlet

POWERSYNC CART FOR iPAD

H3635LL/A

Storage Tub
Inside for extra
cables & connectors
CLOSED
Laser
Numbered
Slots
help identify the
devices & assist
in asset
management
.

Step 4

Store & Charge iPad devices using the

PowerSync Cart

1. Insert each iPad device into a slot and attach the 30-pin

dock connector.

NOTE: the orange Bretford logo should face up on the same side

as iPad device screen.

2. Plug in Power Cord from the right side of the cart.

3. Turn main Power Switch on back of cart to “ON” position.

NOTE: PowerSync Cart will charge up to 30 iPad devices

NOTE: For best results with new iPad devices, charge for about

4 hours or until the iPad device displays a charged battery.

Please follow these instructions for each iPad device used
with your PowerSync Cart:
1. Connect each iPad, one at a time, to the Mac you will
be using with the PowerSync Cart.
2. If iTunes does not open automatically, open iTunes
& select your iPad device.
3. If prompted, complete the naming and registration
process.
4. Select the Summary tab for your iPad device.
5. In the Options section:
Enable “Open iTunes when this iPad is attached” (This
(This not only activates iTunes, but begins the
syncing process.)
Enable “Sync only checked songs & videos”” (This
(This allows for greater control of synced media.)
Disable “Manually manage music & videos” (Enabling
(Enabling this will require that you manually drag
media to this particular iPad.)
4. In the remaining tabs, select the media and playlists
you wish to sync with this iPad device.
5. Click the Sync or Apply button.
(The Sync button changes to Apply & Cancel buttons
when you make a change to the sync settings.)
Repeat these steps with each iPad device in your
collection

Configuring an iPad device for use with PowerSync Cart

NOTE: iPad devices will not charge and sync at the same time!

LED Charging Indicator Lights

LED Lights on TOP of Cart

3 lights - 1 for each section of 10 iPads - glow

amber when charging, turn green when charged

LED Lights on BACK of Cart

1 light for each iPad, shown in sequence per the layout in the

cart for easy identification. Amber charging. Green charged.

View the manual for the Bretford PowerSync H3635 here, for free. This manual comes under the category chargers for mobile devices and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Bretford PowerSync H3635 or do you need help? Ask your question here

Need help?

Do you have a question about the Bretford and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 2
B
BJanuary 14, 2023

How do you open the cart to replace a cord that has gone out?

D
DebbieAugust 8, 2023

How do I replace individual cords in the cart when they have gone bad

The Bretford PowerSync H3635 is a charger designed specifically for mobile devices. It is engineered to provide efficient and reliable charging for a range of devices, including smartphones, tablets, and other portable gadgets. This charger is known for its functionality and practicality. With its sleek and compact design, the Bretford PowerSync H3635 is easily portable and can be conveniently carried around. Its lightweight construction makes it an ideal travel companion for those on the go. The charger features multiple USB ports, allowing users to charge multiple devices simultaneously, saving time and effort. Not only does the Bretford PowerSync H3635 offer convenience, it also boasts impressive charging capabilities. Equipped with advanced technology, this charger delivers fast and efficient charging, ensuring that devices are powered up quickly. This eliminates the frustration of waiting for devices to charge and allows users to stay connected and productive. Safety is a top priority with the Bretford PowerSync H3635. It is designed with built-in protections to prevent overcharging, overheating, and short-circuiting, safeguarding both the charger and the connected devices. This ensures the longevity of the charger and provides peace of mind for users. In conclusion, the Bretford PowerSync H3635 is a reliable and efficient charger for mobile devices. Its portability, multiple USB ports, fast charging capabilities, and safety features make it a practical choice for those in need of a versatile charging solution.

General
BrandBretford
ModelPowerSync H3635
Productcharger for mobile device
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bretford PowerSync H3635 below.

How can I easily store, secure, recharge, sync, and transport up to 30 iPad devices and their host MacBook between classrooms using the PowerSync Cart for iPad?

To easily store, secure, recharge, sync, and transport up to 30 iPad devices and their host MacBook between classrooms using the Bretford PowerSync H3635: 1. Insert each iPad device into a slot on the cart and attach the 30-pin dock connector with the orange Bretford logo facing up. 2. Plug in the Power Cord from the right side of the cart. 3. Turn the main Power Switch on the back of the cart to the "ON" position to start charging the devices. 4. Connect each iPad to the host MacBook one at a time and open iTunes to select and register each device. 5. Configure the sync settings in iTunes for each iPad device by selecting the media and playlists to sync. 6. Click the Sync or Apply button in iTunes to start the syncing process. 7. Repeat these steps for each iPad device in your collection to ensure they are stored, charged, and synced efficiently.

How do I sync iPad devices using the PowerSync Cart and troubleshoot any syncing issues that may arise during the process?

1. Configure iTunes to prevent automatic software updates. 2. Configure each iPad device for use with the PowerSync Cart, noting that devices will not charge and sync simultaneously. 3. Connect each iPad device inside the cart, ensure the Mac is on with no applications running, plug the PowerSync Cart into the wall, connect the USB cable to the Mac, turn on the main power switch on the cart, launch iTunes, wait for each iPad to appear in iTunes, and begin syncing. 4. Eject each iPad device or close iTunes to eject all at once after syncing is complete. 5. Unplug the USB cable from the Mac to allow the iPad devices to charge.

Is the manual of the Bretford PowerSync H3635 available in English?

Yes, the manual of the Bretford PowerSync H3635 is available in English .

Is your question not listed? Ask your question here

No results