Bosch WAQ24461GB manual

Bosch WAQ24461GB
  • Number of pages: 6
  • Filetype: PDF

Safety instructions

The washing machine is heavy - take care when lifting.
Caution: frozen hoses may rip/burst. Do not install the washing machine in areas exposed
to frost or outdoors.
The washing machine could be damaged. Do not lift the appliance by protruding
components (e.g. the washing machine door, the cover, the front panel or the outer door
in case of deco models).
In addition to the instructions provided in this document, special regulations from the
relevant water and electric utility companies may apply.
If in doubt, have a technician connect the appliance.
Lay hoses and cables in such a way that there is no risk of tripping.

Installation surface

The machine must be stable so that it does not move around.
The installation surface must be firm and level.
Soft floors/floor coverings are not suitable.
Installation on a pedestal
The feet of the washing machine must be secured with holding brackets*.
* order no. WMZ2200, WX9756, CZ110600, Z7080X0
Installation on a wood joist floor
If possible, place the washing machine in a corner.
Screw a water-resistant wooden board (min. 30 mm thick) to the floor.
The feet of the washing machine must be secured with holding brackets*.
* order no. see above
Installation on a platform with drawer*
* order no. WMZ20490, WZ20490

Installing the appliance

Install the appliance before connecting it to the power supply.
Installation in a kitchenette (underneath the worktop or fitted in a cabinet)
Recess width of 60 cm required.
Only install the washing machine underneath a continuous worktop that is securely
connected to adjacent cabinets.
Installation underneath the worktop
Risk of electric shock!
Instead of the appliance covering plate, you must have a metal cover*.
* order no. WMZ20331, WZ20331
Recess width of 60 cm required.

Scope of delivery depending on model

Also required, depending on the connection:
1 hose clamp Ø 24-40 mm (exclusive dealers) to connect to a siphon
apage 4; water connection.
Useful tools
Spirit level for installation.
WAF 13: for loosening transport braces apage 3 and
WAF 17: for aligning appliance feet apage 5.

Hose and cable lengths depending on model

Left-hand connection
Right-hand connection
Available from specialist dealers/the after-sales service:
Extension for Aqua-Stop or cold-water inlet hose (approx. 2.50 m),
order no. WMZ2380, WZ10130, CZ11350, Z7070X0
Longer inlet hose (approx. 2.20 m) for standard model.
Mains cable
Water outlet
Water inlet
for fixing the drainage
hose in place
AquaäStop Hot water
AquaäSecure &
Adapter 1/2-3/4
(depending on model)
145 cm
100 cm
100 cm
135 cm
145 cm
min. 60 cm
max. 100 cm
90 cm
Moisture inside the drum
is due to final testing.

Removing the transport braces

Before using the appliance for the first time, make sure that you
completely remove transport braces and keep them for
subsequent transportation.
If you need to transport the appliance at a later date, always re-affix
the transport braces to prevent damage to the machine. apage 6.
Store the screw and sleeve together.
1. Take the hoses out of the holders.
2. Remove all 4 screws completely.
3. Remove all 4 transport braces completely and take the mains cable
out of the holders (depending on model).
4. Affix the covers.

Water connection depending on model

Risk of electric shock. Do not immerse the Aqua-Stop safety device in water
(contains an electric valve).
To prevent leaks or water damage, observe the instructions in this section.
Caution: only operate the washing machine using cold drinking water (in case of models
featured for hot water: maximum temperature 60 ºC).
Do not connect to the mixer tap of an unpressurised hot-water boiler.
Do not use a used inlet hose. Only use the inlet hose supplied or one which was
purchased from an authorised specialist dealer.
If in doubt, have a technician connect the appliance.

Water connection depending on model

Water inlet
Caution: do not bend, squash, modify or cut through
(otherwise its strength is no longer guaranteed).
Optimum water pressure in the supply network: 200ä1,000 kPa (2ä10 bar)
When the tap is on, the water flow is at least 10 l/min
(1-2 bar: 6 l/min; with 1 bar consumption parameters cannot be assure).
If the water pressure is higher than this, a pressure reducing valve must be installed
Connection to the tap:
Aqua-Stop, Aqua-Secure, Standard:
Connection to the
AquaäStop, Aqua-Secure Standard
no necessary with Aqua-
Stop, fixed installation;
Aqua-Secure, Standard
1. Connect the water inlet hose (hoses) to the tap (taps) 3/4" = 26,4 mm and to the solenoid
Caution: only tighten the screw connections by hand.
2. Open the water tap (taps) carefully, checking the leak tightness of the connection points.
Caution: the screw connection is under mains water pressure.
Connection in case of hot water
COLD Cold water
HOT  Hot water max. 60 °C (red)
If no hot water connection is present:
only connect the cold water inlet hose
cover the hot water connection on the
appliance so that it is kept free of dirt.
Water outlet
Caution: do not bend or pull lengthways.
Height difference between the installation surface and the
min. 60 cm - max. 100 cm
Outlet in a sink:
Caution: secure the drain hose from slipping out.
Caution: the plug must not block drainage from the sink. During
pumping, check whether the water is draining away quickly
enough. The end of the drain hose must not be immersed in the
water pumped out. This risks water being sucked back into the
washing machine.
Drainage into a siphon:
Caution: the connection point must be secured with a hose
clamp, Ø 24-40 mm (exclusive dealers).
Bosch WAQ24461GB

Need help?

Number of questions: 0

Do you have a question about the Bosch WAQ24461GB or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Bosch WAQ24461GB owners to properly answer your question.

View the manual for the Bosch WAQ24461GB here, for free. This manual comes under the category Washing Machines and has been rated by 1 people with an average of a 9.2. This manual is available in the following languages: English. Do you have a question about the Bosch WAQ24461GB or do you need help? Ask your question here

Bosch WAQ24461GB specifications

Brand Bosch
Model WAQ24461GB
Product Washing Machine
EAN 4242002711850
Language English
Filetype PDF
Energy efficiency class (old) A+++
Water consumption per cycle 55 L
Energy consumption washing per cycle 0.82 kWh
Current 13 A
Power consumption (max) 2300 W
AC input voltage 220-240 V
AC input frequency 50 Hz
Power consumption (off) 0.1 W
Other features
Annual water consumption washing 8700 L
Annual energy consumption washing 179 kWh
Washing class A
Built-in display
Display type LED
Loading type Front-load
Type Freestanding
Cord length 1.6 m
Door hinge Left
Door opening angle 165 °
Drum volume 58 L
Direct drive technology -
Drum material Stainless steel
Tub material Plastic
Control type Buttons,Rotary
Product colour White
Door colour White
Number of washing programs -
Rated capacity 8 kg
Maximum spin speed 1200 RPM
Spin-drying class B
Cycle time (max) 196 min
Noise level (wash) 54 dB
Delayed start timer
Foam control system
Load balancing system
Delay start (max) 24 h
Residual moisture 58 %
Noise level (spin) 76 dB
Adjustable spin speed
Child lock
Remaining time indication
Weight & dimensions
Width 598 mm
Depth 550 mm
Height 848 mm
Weight 66000 g
Door opening diameter 320 mm
Depth with door open 1018 mm
Packaging data
Package weight 67000 g
Washing programs
Hygiene/anti-allergy washing program
Black washing program
Cotton washing program
Delicate/silk washing program
Easy care washing program
Eco washing program
Hand/wool washing program
Pre-wash program
Quick washing program
Sport washing program
show more

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Bosch WAQ24461GB.

Is your question not listed? Ask your question here