Bosch SMV69U60EU manual

Bosch SMV69U60EU
5.3 · 1
PDF manual
 · 42 pages
English
manualBosch SMV69U60EU
XXXCPTDIIPNFDPNXFMDPNF
3FHJTUFSZPVSOFX#PTDIOPX

%JTIXBTIFS

FO *OTUSVDUJPONBOVBM
SM…
SB…

View the manual for the Bosch SMV69U60EU here, for free. This manual comes under the category dishwashers and has been rated by 1 people with an average of a 5.3. This manual is available in the following languages: English. Do you have a question about the Bosch SMV69U60EU or do you need help? Ask your question here

Need help?

Do you have a question about the Bosch and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandBosch
ModelSMV69U60EU | SMV69U60EU
Productdishwasher
EAN4242002730073
LanguageEnglish
FiletypeUser manual (PDF)
Design
Appliance placementFully built-in
Built-in displayYes
Water fillCold, Hot
Inlet hose length1.4 m
Outlet hose length1.7 m
Cord length1.7 m
Cutlery compartment typeBasket
Built-in water softenerYes
Control typeButtons
Door colorNot applicable
Control panel colorStainless steel
Power
A+++
Water consumption per cycle9.5 L
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Connected load2400 W
Power consumption (off)0.5 W
Current10 A
Energy consumption per cycle0.74 kWh
Performance
Noise level43 dB
Number of washing programs6
Number of place settings14 place settings
Cycle time195 min
Dishwashing programsAuto 35-45°C, Auto 45-65°C, Auto 65-75°C, Eco, Intensive, Pre-wash, Quick
AquaStop functionYes
Delayed start timerYes
Delay start (max)24 h
Number of temperature settings5
Temperature (max)60 °C
Glass protectionYes
Other features
Quick washYes
Annual water consumption2660 L
Pre-wash
Annual energy consumption214 kWh
Weight & dimensions
Width598 mm
Depth550 mm
Height815 mm
Weight46000 g
Installation compartment width600 mm
Installation compartment depth550 mm
Installation compartment height875 mm
Installation compartment height (min)815 mm
Installation compartment height (max)875 mm
Ergonomics
Remaining time indicationYes
Interior lightYes
Salt indicatorYes
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch SMV69U60EU below.

What do I do about a smelly dishwasher?

In the case of a smelly dishwasher, you can take the following steps: - Clean the filters - Clean the spray arms - Clean the door rubbers - Run a hot wash program - Run an empty machine with a dishwasher cleaner

Do you have to pre-rinse the dishes?

It is not recommended to rinse dirty dishes before placing them in the dishwasher. For the life cycle of the machine, it is better to put everything dirty in the dishwasher. The grease on the dirty dishes is the lubrication for the pump in the machine.

How much dishwashing detergent should I use?

The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.

How do I add softening salt to my dishwasher?

Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.

What is the weight of the Bosch SMV69U60EU?

The Bosch SMV69U60EU has a weight of 46000 g.

What is the height of the Bosch SMV69U60EU?

The Bosch SMV69U60EU has a height of 815 mm.

What is the width of the Bosch SMV69U60EU?

The Bosch SMV69U60EU has a width of 598 mm.

What is the depth of the Bosch SMV69U60EU?

The Bosch SMV69U60EU has a depth of 550 mm.

Is the Bosch SMV69U60EU energy efficient?

Yes, the Bosch SMV69U60EU has an energy efficiency class of A+++, which is the highest rating and means it consumes less energy than comparable products.

How loud is the Bosch SMV69U60EU dishwasher?

The Bosch SMV69U60EU has a noise level of 43 dB, which is relatively quiet and ensures a peaceful environment during operation.

How much water does the Bosch SMV69U60EU use per cycle?

The Bosch SMV69U60EU uses 9.5 L of water per cycle, ensuring efficient water usage and reducing the overall water consumption.

How many washing programs does the Bosch SMV69U60EU have?

The Bosch SMV69U60EU has 6 washing programs, offering a variety of options to cater to different cleaning needs and preferences.

How many place settings can the Bosch SMV69U60EU accommodate?

The Bosch SMV69U60EU can accommodate 14 place settings, providing ample space for dishes, glasses, and cutlery, making it suitable for larger households or gatherings.

How do I properly install and connect the Bosch SMV69U60EU dishwasher?

To properly install and connect the Bosch SMV69U60EU dishwasher, follow these steps: 1. Drinking water connection: - Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts. - Ensure that the drinking water connection is not kinked, crushed, or twisted. - If replacing the appliance, always use a new water supply hose. - Check the water pressure, which should be at least 0.05 MPa (0.5 bar) and maximum 1 MPa (10 bar). If the water pressure is higher, connect a pressure-reducing valve. - The minimum inlet rate should be 10 liters/minute. - The dishwasher can be connected to cold or hot water up to a maximum temperature of 60 °C. Connecting to hot water is recommended for energy-saving purposes if the hot water is supplied from a suitable installation. - To set the hot water option, open the door, switch on the ON/OFF switch, hold down the programme button and press the START button until the desired setting is indicated on the digital display. 2. Electrical connection: - Connect the appliance to an alternating current ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with a protective earth conductor. - The socket should be near the appliance and freely accessible. - If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side. - The connection should only be modified by technicians. - A power cord extension should be purchased from customer service if needed. Please note that these steps are a general guide. For detailed instructions and safety precautions, refer to the installation section of the Bosch SMV69U60EU dishwasher manual.

Why is the Bosch SMV69U60EU dishwasher not turning on when I switch it on?

There could be several reasons why the Bosch SMV69U60EU dishwasher is not turning on when you switch it on. Here are some possible causes and troubleshooting steps: 1. Check the power supply: - Ensure that the dishwasher is properly plugged into a functioning power outlet. - Check if there is power in the outlet by plugging in another device. - If there is no power, check the circuit breaker or fuse box and reset or replace as necessary. 2. Verify the water supply: - Make sure the water supply is turned on and the water inlet hose is properly connected to the tap. - Check if the water pressure meets the minimum requirement of 0.05 MPa (0.5 bar) and the maximum of 1 MPa (10 bar). - Ensure that the water inlet hose is not kinked, crushed, or twisted. 3. Check the door: - Ensure that the dishwasher door is fully closed and latched securely. - If the door is not closing properly, check for any obstructions or debris that may be preventing it from closing. 4. Check the control panel: - Make sure the dishwasher is not in standby mode. Press the ON/OFF switch to turn it on. - Check if any buttons on the control panel are stuck or unresponsive. Clean or replace the buttons if necessary. If the dishwasher still does not turn on after following these troubleshooting steps, it is recommended to contact Bosch customer service for further assistance.

How do I change the setting of the optical display on the Bosch SMV69U60EU dishwasher?

To change the setting of the optical display on the Bosch SMV69U60EU dishwasher, follow these steps: 1. Open the dishwasher door. 2. Switch on the ON/OFF switch located on the control panel. 3. Hold down the programme button "#" and simultaneously press the START button until the digital display shows "•:‹....". 4. Release both buttons. 5. The illuminated display of the button "#" will start flashing. 6. Press and hold the programme button "#" until the previously set value, such as "†:‹‚", is displayed on the digital display. 7. Press the programme button "3" repeatedly until the desired value, such as "†:‹ƒ", is displayed on the digital display. 8. Press the START button to save the set value. 9. Close the dishwasher door. Please note that the optical display setting options may vary depending on the model. Refer to the Bosch SMV69U60EU dishwasher manual for specific instructions and additional information.

Why is the digital display on the Bosch SMV69U60EU dishwasher not showing the remaining time correctly?

The digital display on the Bosch SMV69U60EU dishwasher may not show the remaining time correctly due to various reasons. Here are some possible causes and troubleshooting steps: 1. Check the selected programme: The remaining time displayed on the digital display is determined by the selected programme. Different programmes have different durations, so ensure that you have selected the appropriate programme for your needs. 2. Monitor the progress of the programme: The remaining time displayed on the digital display may change during the course of the programme. Factors such as water temperature, number of utensils, and degree of soiling can affect the duration of the programme. Allow the dishwasher to complete the programme, and the remaining time should be updated accordingly. 3. Reset the dishwasher: If the digital display continues to show incorrect remaining time, try resetting the dishwasher. Open the door, switch off the ON/OFF switch, and then switch it back on. This can help recalibrate the display and resolve any temporary issues. 4. Contact customer service: If the issue persists and the digital display consistently shows incorrect remaining time, it is recommended to contact Bosch customer service for further assistance. They can provide specific troubleshooting steps or arrange for a technician to inspect the dishwasher. Please note that these steps are general guidelines, and for detailed instructions and specific troubleshooting information, refer to the Bosch SMV69U60EU dishwasher manual.

Why is the low water level display activated on the Bosch SMV69U60EU dishwasher?

The low water level display on the Bosch SMV69U60EU dishwasher may be activated due to various reasons. Here are some possible causes and troubleshooting steps: 1. Insufficient water supply: - Check if the water inlet hose is properly connected to the tap and not kinked or twisted. - Ensure that the water supply is turned on and the water pressure meets the minimum requirement of 0.05 MPa (0.5 bar) and the maximum of 1 MPa (10 bar). - Verify that the water inlet filter is clean and not clogged. Clean or replace the filter if necessary. 2. Blocked filters or drain: - Check the filters and the area underneath for any debris or blockages. Clean the filters and remove any obstructions. - Ensure that the drain hose is not blocked or kinked. Straighten or clean the hose if needed. 3. Technical fault: - If the low water level display persists despite proper water supply and clean filters, a technical fault may have occurred. - Switch off the dishwasher using the ON/OFF switch, wait for a short time, and then restart the appliance. - If the problem recurs, turn off the tap and unplug the dishwasher. Contact customer service and provide them with the error code displayed, if any. Please note that these steps are general guidelines, and for detailed instructions and specific troubleshooting information, refer to the Bosch SMV69U60EU dishwasher manual.

Is the manual of the Bosch SMV69U60EU available in English?

Yes, the manual of the Bosch SMV69U60EU is available in English .

Is your question not listed? Ask your question here

No results