Bosch SMV 50M50 manual
8.2 · 1
View the manual for the Bosch SMV 50M50 here, for free. This manual comes under the category Dishwashers and has been rated by 1 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Bosch SMV 50M50 or do you need help? Ask your question here
- *9000836605*
- 9000836605 en (9211) 640MV
- 8 Intended use
- Intended use
- ■ This appliance is intended for use in the home and the home environment.
- ■ Use the dishwasher only in the household and only for its designed purpose: for washing domestic dishes.
- Delivery
- Installation
- ■ Following installation, ensure that the back of the dishwasher is not freely accessible (protection against contact due to hot surface).
- ■ Install and connect the appliance according to the installation and assembly instructions.
- ■ Prior to installation, disconnect the dishwasher from the power supply.
- ■ Ensure that the protective conductor system of the domestic supply has been correctly installed.
- ■ The electrical connection conditions must correspond with the specifications on the dishwasher rating plate 9:.
- ■ If the power cord of this appliance is damaged, it must be replaced with a particular power cord.
- ■ If the dishwasher is installed in a high-sided unit, the unit must be secured properly.
- ■ If you install a microwave oven above the dishwasher, the microwave oven may be damaged.
- ■ Install built-under or integratable appliances only under continuous worktops which have been screwed to adjacent cupboards to ensure stability.
- ■ Do not install the appliance near heat sources (radiators, heat storage tanks, cookers or other appliances which generate heat) and do not install under a hob.
- ■ After installing the appliance, ensure that the plug is easily accessible.
- ■ Some models:
- ■ Following installation, ensure that the back of the dishwasher is not freely accessible (protection against contact due to hot surface).
- In daily use
- Childproof lock (door lock)Door lock *
- Damage
- ■ The appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap.
- ■ If the fascia is damaged (cracks, holes, broken buttons), do not operate the appliance. Pull out the mains plug or switch off the fuse. Turn off the tap, call customer service.
- ■ The appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap.
- Disposal
- 7 Protection of the environment
- * Getting to know your appliance
- + Water softening system/Special salt
- Water softening system/Special salt
- Setting
- 1. Find out about the hardness value of your tap water. Your water utility company will help you with this.
- 1. Press programme button 3.
- Water hardness table
- Using special salt
- Using detergents with salt componentDetergents with salt component
- Switching off salt refill indicator/water softening systemSwitching off water softening system
- Water softening system/Special salt
- , Rinse aid
- - Utensils
- Utensils
- Not suitable
- ■ Cutlery and utensils made of wood.
- ■ Delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof.
- ■ Plastic parts not resistant to heat.
- ■ Copper and tin utensils.
- ■ Utensils which are soiled with ash, wax, lubricating grease or ink.
- Glass and utensil damage
- ■ Glass type and glass production process.
- ■ Chemical composition of the detergent.
- ■ Water temperature of the wash programme.
- ■ Use only glasses and porcelain which the manufacturer designates as dishwasher-proof.
- ■ Use a detergent which protects utensils.
- ■ Take glass and cutlery out of the dishwasher as soon as possible after the programme ends.
- ■ Glass type and glass production process.
- Loading the dishwasher
- Unloading the dishwasher
- Cups and glasses
- Pans
- Cutlery basket
- EtagereEtagere *
- Folding spikesFolding spikes *
- Small accessories holder *Small accessories holder
- Knife shelf *Knife shelf
- Adjusting the height of the basketAdjusting the height of the basket *
- Top basket with side levers
- 1. Pull out the top basket 1* out.
- 2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
- 3. To raise the basket, hold the basket on the sides of the upper edge and lift it up.
- 4. Before re-inserting the basket again, ensure that it is at the same height on both sides. Otherwise, the appliance door cannot be closed and the upper spray arm will not be connected to the water circuit.
- 2. To lower the basket, press in the left and then the right lever on the outside of the basket. In doing so, hold the sides of the basket along the upper edge to prevent it from suddenly dropping.
- Top basket with upper and lower roller pairs
- Utensils
- . Detergent
- Intended use
- / Overview of programmes
- Overview of programmes
- The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
- Programme selection
- Information for test institutes
- 0 Additional options
- 1 Operating the appliance
- Operating the appliance
- Programme data
- Aqua sensorAqua sensor *
- Switching on the appliance
- Optical display while the programme is runningOptical display while the programme is running *
- Remaining running time display
- Timer programmingTimer programming *
- 1. Open the door.
- 2. Switch on ON/OFF switch (.
- 3. Press button P + until the digital display h jumps to œ:‹‚.
- 4. Press P + or – button until the displayed time corresponds with your requirements.
- 5. Press START button `, timer programming is activated.
- 6. To delete timer programming, press the P + or – button until h œ:‹‹ is indicated on the digital display.
- 7. Close the door.
- 2. Switch on ON/OFF switch (.
- End of programme
- Automatic switch off after end of programme or interior light*Automatic switch off / interior light
- Switching off the appliance
- Interrupting the programme
- Terminating the programmeTerminating the programme (Reset)
- Changing the programme
- Intensive drying
- Operating the appliance
- 2 Cleaning and maintenance
- Cleaning and maintenance
- Overall condition of the machine
- ■ Check spray arm for grease and limescale deposits.
- ■ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature.
- ■ To ensure that the door seal always remains clean and hygienic, regularly clean it with a damp cloth and a little washing-up liquid.
- ■ If the appliance is switched off for a prolonged period, leave the door ajar to prevent the formation of an unpleasant odour.
- Special salt and rinse aid
- Filters
- Spray arms
- Cleaning and maintenance
- 3 Fault, what to do?
- Fault, what to do?
- Note
- Waste water pump
- 1. First always disconnect the appliance from the power supply.
- 2. Take out top basket 1* and bottom basket 1j.
- 3. Remove the filters 1Z.
- 4. Scoop out water, use a sponge if required.
- 5. Prise out the white pump cover (as illustrated) using a spoon. Grip the cover on the crosspiece and lift diagonally inwards. Remove cover completely.
- 6. Check impeller wheel and remove any foreign objects.
- 7. Place cover in the original position and press down until it engages (click).
- 8. Install filters.
- 9. Re-insert baskets.
- Fault table
- 2. Take out top basket 1* and bottom basket 1j.
- Fault, what to do?
- 4 Customer service
- 5 Installation and connection
- Installation and connection
- 1. Checking appliance on delivery
- ■ Dishwasher
- ■ Instructions for use
- ■ Installation instructions
- ■ Warranty*
- ■ Installation materials
- ■ Steam guard plate*
- ■ Rubber apron*
- ■ Power cord
- Safety instructions
- Delivery
- Technical specifications
- Installation
- ■ A built-under or integrated appliance which is installed subsequently as a free-standing appliance must be secured to prevent it from overturning, e.g. by screwing it to the wall or by installing it under a continuous worktop which is screwed to ...
- ■ The appliance can easily be installed in a fitted kitchen between wooden and plastic walls.
- ■ A built-under or integrated appliance which is installed subsequently as a free-standing appliance must be secured to prevent it from overturning, e.g. by screwing it to the wall or by installing it under a continuous worktop which is screwed to ...
- Waste-water connection
- Fresh water connection
- Warm water connection *Warm water connection
- Electrical connection
- ■ Connect the appliance to an alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with protective earth conductor. See rating plate for required fusing 9:.
- ■ The socket must be near the appliance and freely accessible following installation.
- ■ The connection may be modified by technicians only.
- ■ A power cord extension may be purchased from customer service only.
- ■ Use only a residual current operated circuit-breaker which features the symbol ‚. Only this extension guarantees compliance with the currently valid regulations.
- ■ The appliance features a water damage protection system. Please note the system will not function unless the power supply is connected.
- ■ Connect the appliance to an alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with protective earth conductor. See rating plate for required fusing 9:.
- Removing the appliance
- Transportation
- Drain the appliance according to the following steps:
- 1. Turn on the tap.
- 2. Open the door.
- 3. Switch on ON/OFF switch (.
- 4. Select programme with the highest temperature.
- 5. Press START button `.
- 6. Close the door.
- 7. Open door after approx. 4 minutes.
- 8. Press START button ` until ‹:‹‚ is indicated on the digital display.
- 9. Close the door.
- 10. Open door after approx. 1 minute.
- 11. Switch off ON/OFF switch (.
- 12. Turn off the tap, disconnect supply hose and drain water.
- 2. Open the door.
- Drain the appliance according to the following steps:
- Protection against frostProtection against frost (Emptying the appliance)
- Installation and connection
- Overview of programmes
- *9000836605*
- 9000836605 en (9211) 640MV
General
| Bosch | |
| SMV 50M50 | |
| Dishwasher | |
| English | |
| User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch SMV 50M50 below.
What do I do about a smelly dishwasher?
In the case of a smelly dishwasher, you can take the following steps: - Clean the filters - Clean the spray arms - Clean the door rubbers - Run a hot wash program - Run an empty machine with a dishwasher cleaner
Do you have to pre-rinse the dishes?
It is not recommended to rinse dirty dishes before placing them in the dishwasher. For the life cycle of the machine, it is better to put everything dirty in the dishwasher. The grease on the dirty dishes is the lubrication for the pump in the machine.
How much dishwashing detergent should I use?
The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.
How do I add softening salt to my dishwasher?
Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.
Is the manual of the Bosch SMV 50M50 available in English?
Yes, the manual of the Bosch SMV 50M50 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Bosch and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Bosch owners to provide you with a good answer.
Number of questions: 0