Bosch SHP65CM5N manual

Bosch SHP65CM5N
8.8 · 1
PDF manual
 · 40 pages
English
manualBosch SHP65CM5N
Basic settings en-us
21
Basic settings

13 Basic settings

Basic settings
You can configure the basic settings for your appliance to meet your needs.
13.1 Overview of the basic settings
The basic settings depend on the features of your appliance.
Basic setting Selection Description
Rinse aid disp. Scale with 4 levels Set or switch off the amount of rinse
aid to be dispensed.
→
"Setting the amount of rinse aid",Page15
Intensive drying On
Off
1
Switch intensive drying on or off for
each operation.
The temperature in the final rinse is
increased for a better drying result.
This may increase the run time slightly.
Note:Please take care with delicate
dishware.
→
"Setting intensive drying", Page21
Signal volume Scale with 4 levels Adjusting the signal volume.
→
"Setting the signal volume",Page22
Wi-Fi On
Off
1
Switch the wireless network connection
on or off.
→
"Setting Wi-Fi", Page21
The basic setting is not available until
you have connected the appliance with
the HomeConnect® app.
→
"HomeConnect® ", Page22
Factory setting Reset Restore changed settings to the factory
settings.
The settings for initial use must be
configured.
1
Factory setting (may vary according to model)
Tip:Connect your appliance to a mobile device. You can
conveniently change all settings using the
HomeConnect® app.
→
"HomeConnect® quick start", Page23
Setting intensive drying
1. Press ⁠.
2. To open the appliance settings, press button for 3
seconds.

1

2

3

A

A
a The refill indicator for rinse aid flashes.
3. Press button repeatedly until the Clean and Sanitize
LEDs flash.
4. Press button repeatedly until the LED (1) lights up.

1

2

3

A

1
If the LED is not lit up, intensive drying is switched off.
If the LED is lit up, intensive drying is switched on.
5. To store the settings, press button for 3 seconds.
Setting Wi-Fi
1. Press ⁠.

View the manual for the Bosch SHP65CM5N here, for free. This manual comes under the category dishwashers and has been rated by 1 people with an average of a 8.8. This manual is available in the following languages: English. Do you have a question about the Bosch SHP65CM5N or do you need help? Ask your question here

Need help?

Do you have a question about the Bosch and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 5
D
DaveJanuary 8, 2024

Can I put a door on this dishwasher to match the cabinets in my kitchen?

S
sandra Taylor-VoseFebruary 10, 2024

All the buttons on my dishwasher are blinking and I cannot change it

L
Larry D ShapiroApril 21, 2024

how do i contact bosch phone help

K
kathy wolkeFebruary 26, 2024

how do i reset factory settings

C
Colette McCollumMarch 18, 2024

DISHES ARE NOT DRY AT THE END OF THE CYCLE

The Bosch SHP65CM5N is a dishwasher that offers efficient cleaning performance for your dishes. This dishwasher is designed with advanced features and modern technology to make your dishwashing experience more convenient. One of the key features of the Bosch SHP65CM5N is its ability to handle a large capacity of dishes. With its spacious interior and adjustable racks, you can easily fit in all your dirty dishes, pots, and pans. The dishwasher also offers different washing programs, allowing you to choose the appropriate settings for different types of dishes and levels of dirtiness. In terms of performance, the Bosch SHP65CM5N is known for its powerful cleaning capabilities. It utilizes advanced technology to ensure that every corner and surface of your dishes is thoroughly cleaned. It also has a built-in sensor that detects and adjusts the water and detergent usage according to the level of dirtiness, resulting in optimal cleaning results. In addition to its cleaning capabilities, the Bosch SHP65CM5N is designed with noise reduction features. It operates quietly, allowing you to focus on other tasks without being disturbed by loud noises. The dishwasher is also designed with ease of use in mind. It has a user-friendly control panel that allows you to easily select the desired washing program and monitor the progress of the cycle. It also has a delay start function, which allows you to conveniently schedule the dishwasher to start at a later time. Overall, the Bosch SHP65CM5N is a reliable and efficient dishwasher that offers powerful cleaning performance and user-friendly features. It is a great addition to any kitchen, ensuring that your dishes are always clean and ready to use.

General
BrandBosch
ModelSHP65CM5N
Productdishwasher
LanguageEnglish
FiletypeUser manual (PDF), Use and Care Manual (PDF), Installation Guide (PDF), Quickstart Guide (PDF), Datasheet (PDF), Warranty information (PDF), Energy label (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch SHP65CM5N below.

What do I do about a smelly dishwasher?

In the case of a smelly dishwasher, you can take the following steps: - Clean the filters - Clean the spray arms - Clean the door rubbers - Run a hot wash program - Run an empty machine with a dishwasher cleaner

Do you have to pre-rinse the dishes?

It is not recommended to rinse dirty dishes before placing them in the dishwasher. For the life cycle of the machine, it is better to put everything dirty in the dishwasher. The grease on the dirty dishes is the lubrication for the pump in the machine.

How much dishwashing detergent should I use?

The average amount used is about 25 grams of dishwashing detergent. It is recommended to follow the advice on the packaging.

How do I add softening salt to my dishwasher?

Each dishwasher has a separate compartment for softening salt. It opens when you turn the knob on the compartment. The softening salt can then be poured into the compartment by means of a funnel.

How often should I clean the filter of the Bosch SHP65CM5N dishwasher?

To clean the filter of the Bosch SHP65CM5N dishwasher, follow these steps: 1. Make sure the dishwasher is turned off and the door is fully open. 2. Locate the filter at the bottom of the dishwasher. It is usually a cylindrical or rectangular shape. 3. Twist the filter counterclockwise or lift it up, depending on the design, to remove it from the dishwasher. 4. Rinse the filter under running water to remove any debris or food particles. Use a soft brush or sponge to gently scrub the filter if necessary. 5. Inspect the filter for any damage or clogs. If the filter is damaged, replace it with a new one. 6. Once the filter is clean and in good condition, place it back into the dishwasher. Twist it clockwise or push it down to secure it in place. 7. Close the dishwasher door and ensure it is latched properly. 8. You should clean the filter 3-12 times a year, depending on your usage. Regularly cleaning the filter helps maintain the dishwasher's performance and prevents clogs. Remember to consult the Bosch SHP65CM5N dishwasher manual for specific instructions and illustrations related to cleaning the filter.

Why are there still food particles on my dishes after running a cycle with the Bosch SHP65CM5N dishwasher?

There could be several reasons why there are still food particles on your dishes after running a cycle with the Bosch SHP65CM5N dishwasher. Here are some possible causes and troubleshooting steps: 1. Inadequate clearance between dishes: Make sure there is enough space between the dishes to allow water and detergent to reach all surfaces. Avoid overcrowding the dishwasher. 2. Blocked spray arms: Check that the spray arms are not blocked by food particles or other debris. Remove any obstructions and ensure that the spray arms can rotate freely. 3. Dirty filter: A dirty filter can prevent proper water circulation and lead to poor cleaning performance. Clean the filter by removing it from the dishwasher and rinsing it under running water. Use a soft brush or sponge to gently scrub away any stubborn debris. 4. Incorrect cycle selection: Ensure that you are selecting the appropriate cycle for the level of soil on your dishes. The Heavy cleaning cycle is recommended for heavily soiled dishes. 5. Water temperature: If the incoming water is not hot enough, the dishwasher may struggle to effectively remove food particles. Check that the water heater is set to a suitable temperature. By following these troubleshooting steps, you can improve the cleaning performance of your Bosch SHP65CM5N dishwasher and reduce the presence of food particles on your dishes.

How do I adjust the height of the upper rack using the Rackmatic® feature on the Bosch SHP65CM5N dishwasher?

To adjust the height of the upper rack using the Rackmatic® feature on the Bosch SHP65CM5N dishwasher, follow these steps: 1. Open the dishwasher door and locate the Rackmatic® levers on both sides of the upper rack. 2. Push in on the side levers simultaneously to release the rack from its current position. 3. While holding the levers, lift or lower the upper rack to the desired height. 4. Release the levers to lock the rack in place at the new height. 5. Ensure that the rack is securely locked and does not wobble or move when gently pulled. 6. Repeat the process if you need to adjust the height further or for the other side of the rack. By using the Rackmatic® feature, you can easily customize the height of the upper rack to accommodate larger items or to create more space for taller dishes on the lower rack. This flexibility allows for optimal loading and efficient use of the dishwasher's capacity.

Why is the cycle of the Bosch SHP65CM5N dishwasher taking a long time to complete?

The cycle of the Bosch SHP65CM5N dishwasher may take a long time to complete due to the following reasons: 1. Heavy soil detection: The dishwasher's sensors automatically increase the cycle time when heavy soil is detected. This ensures a thorough wash and removes stubborn food particles. 2. Incoming water temperature: If the incoming water is not hot enough, the dishwasher may need to heat it, which can extend the cycle time. Check that the water heater is set to an appropriate temperature. 3. Cycle selection: Certain cycles, such as the Heavy cleaning cycle, are designed to provide a more intensive wash and may have longer run times compared to other cycles. Ensure that you have selected the appropriate cycle for your dishes' level of soil. To optimize the cycle time of your Bosch SHP65CM5N dishwasher, you can: - Pre-rinse dishes: Removing excess food particles before loading the dishwasher can help reduce the cycle time. - Use the appropriate cycle: Select the cycle that matches the level of soil on your dishes to avoid unnecessary prolongation. - Ensure proper water temperature: Check that the water heater is set to a suitable temperature to provide hot water for the dishwasher. By following these steps, you can help reduce the cycle time and ensure efficient cleaning with your Bosch SHP65CM5N dishwasher.

How do I reset the Bosch SHP65CM5N dishwasher to factory settings?

To reset the Bosch SHP65CM5N dishwasher to factory settings, follow these steps: 1. Press the "ON/OFF" button to turn on the dishwasher. 2. Hold down Button A for 3 seconds until the Rinse Aid indicator light flashes. 3. Release the button and follow the specific steps below to adjust the setting you want to reset: - To reset the rinse aid setting: Press the "Start" button repeatedly until the desired rinse aid level is set (0 for off, 1 for low, 2 for medium, or 3 for high). The corresponding LEDs above the cycle buttons will light up accordingly. Press Button A for 3 seconds to save the setting. - To reset the intensive drying setting: Press Button A until the "Clean" and "Sanitize" lights flash. Press the "Start" button until 1 LED light above the heavy cycle button is on (indicating that intensive dry is on). Press Button A for 3 seconds to save the setting. - To reset the signal volume setting: Press Button A until the "Clean" and "Rinse Aid" lights flash. Press the "Start" button repeatedly until the preferred volume level is selected (0 for off, 1 for low, 2 for medium, or 3 for high). The corresponding LEDs above the cycle buttons will light up accordingly. Press Button A for 3 seconds to save the setting. 4. To reset all settings to factory defaults: Press Button A until the "Clean," "Sanitize," and "Rinse Aid" lights flash. Press the "Start" button. The three LEDs above the cycle buttons will blink alternatively for 1 minute, indicating that the factory settings have been restored. By following these steps, you can easily reset the Bosch SHP65CM5N dishwasher to its factory settings.

Is the manual of the Bosch SHP65CM5N available in English?

Yes, the manual of the Bosch SHP65CM5N is available in English .

Is your question not listed? Ask your question here

No results