View the manual for the Bosch Serie 6 WAT28490ES here, for free. This manual comes under the category washing machines and has been rated by 4 people with an average of a 9.2. This manual is available in the following languages: English. Do you have a question about the Bosch Serie 6 WAT28490ES or do you need help? Ask your question here

The Bosch Serie 6 WAT28490ES washing machine is a freestanding appliance designed to efficiently clean your laundry. With an energy efficiency class of A+++, it is highly energy efficient, ensuring lower electricity consumption and reduced environmental impact. It has an annual energy consumption of 152 kWh, making it a cost-effective choice in the long run. Featuring a large rated capacity of 9 kg, this washing machine is capable of handling sizable laundry loads. Its spin-drying class is B, which means it effectively removes excess water from your clothes, reducing drying time. The spin noise level is measured at 75 dB, which is relatively loud, while the wash noise level is 49 dB, providing a quieter operation during the washing process. The Bosch Serie 6 WAT28490ES is equipped with a quick washing program that completes a cycle in just 15 minutes, allowing you to wash small loads quickly and efficiently. The built-in display provides easy-to-read information about the selected program and cycle status, enhancing convenience and usability. Additionally, this washing machine has low power consumption in standby and off modes, consuming only 0.43 W in standby and 0.12 W when turned off, reducing unnecessary energy waste. Overall, the Bosch Serie 6 WAT28490ES washing machine offers an energy-efficient and convenient solution for your laundry needs. With its large capacity, quick wash option, and reliable performance, it ensures effective cleaning results while saving energy and water.
| Brand | Bosch |
| Model | Serie 6 WAT28490ES | WAT28490ES |
| Product | washing machine |
| EAN | 4242002977195 |
| Language | English |
| Filetype | Installation Guide (PDF) |
| A+++ | |
| Energy consumption washing per cycle | 0.92 kWh |
| Power consumption (off) | 0.12 W |
| Power consumption (standby) | 0.43 W |
| Connected load | 2300 W |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Current | 10 A |
| Annual energy consumption washing | 152 kWh |
| Annual water consumption washing | 11220 L |
| Washing class | A |
| Drum capacity | 9 kg |
| Spin-drying class | B |
| Noise level (spin) | 75 dB |
| Noise level (wash) | 49 dB |
| Cycle time (quick washing program) | 15 min |
| Delayed start timer | Yes |
| Delay start (max) | 24 h |
| Timer | Yes |
| Load balancing system | Yes |
| Hygiene/anti-allergy, Black, Blouse/shirt, Cotton, Mix, Quick, Sport, Synthetics, Delicate/silk | |
| Maximum spin speed | 1379 RPM |
| Cycle time (max) | 275 min |
| AquaStop function | Yes |
| Adjustable spin speed | Yes |
| Half-load | Yes |
| Number of washing programs | - |
| Overflow protection | Yes |
| Residual moisture | 53 % |
| Appliance placement | Freestanding |
| Loading type | Front-load |
| Product color | White |
| Built-in display | Yes |
| Certification | CE, VDE |
| Motor type | Brushless |
| Control type | Rotary, Touch |
| Tub material | Plastic |
| Water fill | Cold |
| Door color | White |
| Drum material | Stainless steel |
| Door hinge | Left |
| Display type | LED |
| Cord length | 1.6 m |
| Width | 598 mm |
| Depth | 590 mm |
| Height | 848 mm |
| Weight | 70000 g |
| Depth with door open | 1030 mm |
| Installation compartment height | 860 mm |
| Package weight | 71000 g |
| Self-cleaning | Yes |
| LED program stage indicator | Yes |
| Remaining time indication | Yes |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch Serie 6 WAT28490ES below.
The washing label of your garment shows the recommended washing temperature.
It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.
Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.
The Bosch Serie 6 WAT28490ES has a weight of 70000 g.
The Bosch Serie 6 WAT28490ES has the following certifications: CE, VDE.
The Bosch Serie 6 WAT28490ES has a height of 848 mm.
The Bosch Serie 6 WAT28490ES has a width of 598 mm.
The Bosch Serie 6 WAT28490ES has a depth of 590 mm.
The energy efficiency class of the Bosch Serie 6 WAT28490ES is A+++.
The Bosch Serie 6 WAT28490ES has an annual energy consumption for washing of 152 kWh.
The rated capacity of the Bosch Serie 6 WAT28490ES is 9 kg.
The spin-drying class of the Bosch Serie 6 WAT28490ES is B. This means it may not be as efficient in drying clothes compared to machines with higher spin-drying classes.
Yes, the Bosch Serie 6 WAT28490ES does have a built-in display. This feature allows the user to easily monitor and control the washing machine's settings and functions.
To address odours in the Bosch Serie 6 WAT28490ES washing machine, follow these steps: 1. Depending on the model, run the "Drum Clean" or "Cottons" program without any laundry. Set the temperature to 90°C. 2. Add standard washing powder or a detergent that contains bleach. To prevent foaming, use only half the amount of detergent recommended by the detergent manufacturer. Do not use detergents intended for woollens or delicates. 3. If foam is leaking from the detergent drawer or the Å symbol is lit on the display panel, it may indicate that you have used too much detergent. Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into compartment II (not suitable for outdoor clothing, sportswear, or items made with down). 4. Use less detergent in the next wash cycle to avoid detergent residue on the laundry. 5. If there is still detergent residue on the laundry, select the "Rinse" program or brush the laundry after washing to remove any water-insoluble residue. 6. If you encounter any faults or issues that you cannot resolve, such as persistent odours or other problems, contact the after-sales service for assistance. Remember to always follow the instructions in the manual for your specific model of the Bosch Serie 6 WAT28490ES washing machine.
To address loud noises and vibrations during the spin cycle of the Bosch Serie 6 WAT28490ES washing machine, follow these steps: 1. Check if the appliance is level. If not, adjust the leveling feet to make the appliance level. Refer to page 33 of the manual for instructions. 2. Ensure that the appliance's feet are securely tightened. Loose feet can cause vibrations. Secure the feet properly according to the instructions on page 33 of the manual. 3. Make sure that the transport braces have been removed. These braces are used to secure the drum during transportation and should be removed before using the washing machine. Refer to page 30 of the manual for guidance on removing the transport braces. If the above steps do not resolve the issue, consider the following: 4. Check if there has been a power failure. If so, restore power to the washing machine. 5. Verify if the fuses have blown or if the circuit breaker has tripped. If necessary, replace the fuses or switch on the circuit breaker. If the problem persists or if you are unable to resolve it, contact the after-sales service for further assistance. Please note that these troubleshooting steps are specific to the Bosch Serie 6 WAT28490ES washing machine and may not apply to other models.
If the display panel and indicator lights are not working while the Bosch Serie 6 WAT28490ES washing machine is running, you can try the following steps: 1. Check if the temperature is too high. If so, wait until the temperature drops before continuing the program. 2. Ensure that the water level is not too high. If it is, you will not be able to add laundry. Close the door immediately if necessary and press the A button to continue the program. 3. If the display panel shows the "è" symbol flashing, there may be trapped laundry. Open and close the door again and press the A button. If necessary, push the door closed or remove the trapped laundry and then push it closed again. 4. If the display panel shows the "r" symbol lit up, turn on the cold water tap fully. Check if the supply hose is kinked or jammed and correct its position if necessary. Also, clean the filter to ensure proper water pressure. 5. If the childproof lock is activated, deactivate it. Refer to page 18 of the manual for instructions on how to do this. If these steps do not resolve the issue, or if you encounter other displays or faults not mentioned here, it is recommended to switch off the appliance, wait for five seconds, and then switch it on again. If the problem persists, contact the after-sales service for further assistance.
Common faults that may occur with the Bosch Serie 6 WAT28490ES washing machine and their troubleshooting steps are as follows: 1. Water is leaking from the machine: - Check and attach the drain hose correctly or replace it. - Tighten the threaded joint on the supply hose. 2. Detergent is not being dispensed: - Press the A button to ensure the program is activated. - Check if the tap is turned on. - Clean the filter if it is clogged. 3. The door will not open: - Check if the safety function is active and stop the program if needed. - Deactivate the childproof lock if it is activated. - Ensure that the selected program allows for the door to be opened. 4. The program will not start: - Press the A button to start the program. - Check if the "Finished in-time" option is selected. - Ensure that the door is closed properly. - Deactivate the childproof lock if it is activated. 5. The drum briefly jerks or judders after the program has started: - This is not a fault but a normal occurrence during the internal motor test. 6. The water is not draining: - Check if the "Rinse Stop" option is selected. - Clean the drain pump and the drain pipe/hose. 7. The spin result is not satisfactory: - This may happen if the load is unevenly distributed. Distribute the laundry evenly in the drum. - Check if the selected speed is appropriate for the load. 8. The program is taking longer than usual: - This may happen if the load is unbalanced or if the foam detection system is active. 9. Water remaining in the care product compartment: - This is not a fault and does not affect the effectiveness of the care product. Clean the insert if necessary. If the issue persists or if you encounter other faults not mentioned here, it is recommended to contact the after-sales service for further assistance.
To properly set up and level the Bosch Serie 6 WAT28490ES washing machine and prevent it from "wandering" during the spin cycle, follow these steps: 1. Place the washing machine on a solid and level surface. Avoid placing it on a carpet or uneven flooring. 2. Adjust the leveling feet to ensure the appliance is level. Use a spirit level to check the machine's horizontal position. If needed, turn the feet clockwise to raise the machine or counterclockwise to lower it. 3. Once the machine is level, tighten the locking nuts on the leveling feet to secure the position. 4. Check that the machine is stable and does not wobble when gently pushed from different sides. If it wobbles, readjust the leveling feet until it is stable. 5. Ensure that the washing machine is not overloaded. Follow the recommended load capacity mentioned in the manual. 6. Distribute the laundry evenly in the drum to prevent an unbalanced load. Avoid washing single heavy items or a small number of large items. By following these steps, you can properly set up and level the Bosch Serie 6 WAT28490ES washing machine, reducing the chances of it "wandering" during the spin cycle and ensuring optimal performance.
Yes, the manual of the Bosch Serie 6 WAT28490ES is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Bosch and is the answer not in the manual?
Question and answer
Number of questions: 3The colored laundry is washed for at least 3 hours, which seems too long to me, and that's on reduced 800 RPM. Can the washing time be set to normal? Is it only over 3 hours or is around 2 hours also acceptable?
Hello! This is blinking on the display of the Serie 6 washer-dryer. The door cannot be opened or any program changed. It happened during the night while it was washing and drying.
Desative o bloqueio de segurança para crianças