View the manual for the Bosch Rotak 40 M here, for free. This manual comes under the category lawnmowers and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Bosch Rotak 40 M or do you need help? Ask your question here
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Bosch Rotak 40 M below.
When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.
In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.
You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.
To troubleshoot if the motor of your Bosch Rotak 40 M lawnmower refuses to start, follow these steps: 1. Check if the power is turned on. 2. Use another mains socket in case the current one is faulty. 3. Inspect the extension cable for any damage and replace if necessary. 4. Replace the fuse if it is faulty or blown. 5. If the grass is too long, increase the height of cut and tilt the lawnmower to reduce the starting load. 6. Allow the motor to cool down if the motor protector has activated, and increase the height of cut. 7. If the machine functions intermittently, check for damaged extension cables and replace if needed. 8. Contact a Service Agent if the internal wiring of the machine is damaged. 9. Tighten the blade nut/bolt (17 Nm) if the blade is not rotating while the lawnmower is switched on.
To troubleshoot if the Bosch Rotak 40 M lawnmower leaves a ragged finish or if the motor labors, follow these steps: 1. Increase the height of cut to prevent a ragged finish. 2. Replace the cutting blade if it is blunt. 3. Check underneath the lawnmower for possible clogging and clear it out if necessary. 4. Ensure the cutting blade is fitted correctly and not upside down. 5. Switch off the lawnmower and clear any obstructions if the blade is not rotating while the lawnmower is switched on. 6. Tighten the blade nut/bolt to address excessive vibrations or noise. 7. If the issue persists, consider replacing the cutting blade. These steps should help resolve the ragged finish and motor labor issues with your Bosch Rotak 40 M lawnmower.
Yes, the manual of the Bosch Rotak 40 M is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Bosch and is the answer not in the manual?
Question and answer
Number of questions: 0