Black & Decker STC1840PC manual

Black & Decker STC1840PC
5.7 · 1
PDF manual
 · 128 pages
English
manualBlack & Decker STC1840PC
2
3
E
F
C
D
13
10
18
16
16
19
14
15
17
20
20
A
B
12
12

Manual

View the manual for the Black & Decker STC1840PC here, for free. This manual comes under the category grass trimmers and has been rated by 1 people with an average of a 5.7. This manual is available in the following languages: English. Do you have a question about the Black & Decker STC1840PC or do you need help? Ask your question here

Need help?

Do you have a question about the Black & Decker and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Black & Decker STC1840PC specifications

Below you will find the product specifications and the manual specifications of the Black & Decker STC1840PC.

General
BrandBlack & Decker
ModelSTC1840PC
Productgrass trimmer
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Black & Decker STC1840PC below.

How short should I cut the grass?

When the grass is longer than 4.5cm, the grass should be cut. The ideal length is between 3 and 4.5cm.

How often should I cut the grass?

In the spring, the grass should be cut every week, while in the summer once every two weeks is sufficient.

Can I mow the lawn when the grass is wet?

You can, but the result is better in dry weather. When the grass is wet, grass clumps can easily form and clog the mower.

How can I ensure that the cutting line is fed properly during usage?

To ensure that the cutting line is fed properly during usage of the Black & Decker STC1840PC grass trimmer, follow these steps: 1. Inspect the tracks at the bottom of the spool for damage. If damaged, replace the spool. 2. Pull the cutting line until it protrudes approximately 122 millimeters from the spool. If there is insufficient cutting line left, install a new spool of cutting line. 3. Align the tabs on the spool cap with the cutouts in the housing and push the spool cap securely into place. 4. If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade. 5. Ensure you are using the correct line size and diameter (2.00 mm) for proper functionality of the auto feed system. 6. Clean the spool and housing regularly and make sure the lever in the spool housing can move freely. 7. Avoid overfeeding by cutting with the tip of the line 177 millimeters from the spool and maintaining a proper cutting angle.

What steps should I take if the cutting line becomes jammed or tangled while using the trimmer?

1. Remove the battery from the trimmer. 2. Press the release tabs on the line spool cap and remove the cap. 3. Pull the nylon line spool out and clear any broken line or cutting debris. 4. Place the spool and line into the spool cap with the line "parked" in the slots provided. 5. Insert the line end through the appropriate hole in the spool housing and pull slack line through until it pulls out of the holding slots. 6. Press the spool down gently and rotate it until it drops into place, then push to snap into place. 7. Ensure the line is not trapped under the spool. 8. Align the spool cap tabs with the slots on the spool housing and snap the spool cap back on securely.

Is the manual of the Black & Decker STC1840PC available in English?

Yes, the manual of the Black & Decker STC1840PC is available in English .

Is your question not listed? Ask your question here

No results