You can also press Source on the projector or remote control to select your
desired input signal. See
"Switching input signal" on page 33 for details.
•If no signal is detected for 3 minutes, the projector automatically enters
ECO BLANK mode.
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 front adjuster foot and 2 rear adjuster feet. These
adjusters change the image height and projection angle. To adjust the projector:
1.Pull the quick-release lever and lift the front
of the projector. Once the image is
positioned where you want it, release the
quick-release lever to lock the foot in
position. You may also screw the front
adjuster foot to change the image height.
2.Screw the rear adjuster feet to fine tune the
horizontal angle.
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected image becomes trapezoidal. To correct
this situation, see
"Magnifying and searching for details" on page 34 for details.
•Do not look into the lens while the lamp is on. The strong light from the
lamp may cause damage to your eyes.
•Be careful when you press the adjuster button as it is close to the
exhaust vent where hot air comes from.
Manual
View the manual for the BenQ TW535 here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.8. This manual is available in the following languages: English. Do you have a question about the BenQ TW535 or do you need help? Ask your question here
Do you have a question about the BenQ and is the answer not in the manual?
Receive updates on solutions
Get answers to your question
Question and answer
Number of questions: 1
C
Carsten IversenFebruary 19, 2022
My BenQ TW535 projector does not receive signal from my PC running Windows 10 Home edition. I have tried using USB and connection via HDMI. My PC register a connection but no signal.
I think the problem is on the PC/windows
+3
BenQ TW535 specifications
Below you will find the product specifications and the manual specifications of the BenQ TW535.
Need help?
Do you have a question about the BenQ and is the answer not in the manual?
Question and answer
Number of questions: 1My BenQ TW535 projector does not receive signal from my PC running Windows 10 Home edition. I have tried using USB and connection via HDMI. My PC register a connection but no signal. I think the problem is on the PC/windows