BenQ PW9520 manual

BenQ PW9520
7.6 · 1
PDF manual
 · 75 pages
English
manualBenQ PW9520

English

59
LED indicator LED status Possible cause
Lamp indicator
Red blinks
The lamp does not illuminate
No lamp is installed or lamp should be replaced.
9
Install the lamp or check if the lamp is installed
properly.
Red blinks 2 times
(Repeatedly)
The lamp does not illuminate
The lamp is shut down abnormally.
The lamp is burnt out
Lamp circuit failure
Contact with your nearest authorized dealer or
service center.

Common problems and solutions

These guidelines provide tips to deal with problems you may encounter while using the projector.
If the problem remains unsolved, contact your dealer for assistance.
Often the problem is something as simple as a loose connection. Check the following before
proceeding to the problem-specic solutions.
Use some other electrical device to conrm that the electrical outlet is working.
Ensure the projector is turned on.
Ensure all connections are securely attached.
Ensure the attached device is turned on.
Ensure a connected PC is not in suspend mode.
Ensure a connected notebook computer is congured for an external display. (This is usually
done by pressing an Fn-key combination on the notebook.)

Tips for troubleshooting

In each problem-specic section, try the steps in the order suggested. This may help you to solve
the problem more quickly.
Try to pinpoint the problem to avoid replacing non-defective parts.
For example, if you replace batteries and the problem remains, put the original batteries back and
go to the next step.
Keep a record of the steps you take when troubleshooting: The information may be useful when
calling for technical support or for passing on to service personnel.

Image problems

Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.

Manual

View the manual for the BenQ PW9520 here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 7.6. This manual is available in the following languages: English. Do you have a question about the BenQ PW9520 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the BenQ and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

BenQ PW9520 specifications

Below you will find the product specifications and the manual specifications of the BenQ PW9520.

General
BrandBenQ
ModelPW9520 | 9H.JDF77.26E
Productvideo projector
EAN0840046032326, 4718755057250
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness6000 ANSI lumens
Projection technologyDLP
Projector native resolutionWXGA (1280x720)
Screen size compatibility80 - 500 "
Native aspect ratio16:10
Projection distance- m
Contrast ratio (typical)2800:1
Number of colors1.073 billion colors
Keystone correction, horizontal-30 - 30 °
Keystone correction, vertical-30 - 30 °
Vertical scan range23 - 85 Hz
Horizontal scan range31 - 92 kHz
Matrix size0.7 "
Matrix type3-panel (p-Si TFT active)
Lens system
Zoom ratio1.3:1
Focal length range26 - 34 mm
Aperture range (F-F)1.64 - 1.86
Horizontal lens shift range-10 - 10 %
Vertical lens shift range0 - 50 %
Throw ratio1.81 - 2.38
Light source
Service life of light source2500 h
Service life of light source (economic mode)3000 h
Lamp power280 W
Light source typeLamp
Video
Analog signal format systemNTSC, PAL, SECAM
Full HDNo
3DNo
Supported graphics resolutions640 x 480 (VGA), 1920 x 1200 (WUXGA)
Ports & interfaces
VGA (D-Sub) ports quantity1
HDMI ports quantity1
USB 2.0 ports quantity1
Composite video in1
Component video (YPbPr/YCbCr) in0
HDMI version1.4
PC in (D-Sub)Yes
DVI portYes
Remote (IR) output2
S-Video inputs quantity1
12V triggerYes
Audio (L/R) in0
HDMI connector typeFull-size
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Ethernet LANYes
Wi-Fi-
Other features
RS-232 ports1
Storage
Card reader integratedNo
Features
HDCPYes
Preset modesGame, Presentation, Standard
On Screen Display (OSD)Yes
On Screen Display (OSD) languagesCHI (SIMPL), DEU, ENG, ESP, FRE, ITA, JPN, KOR, POR, RUS, SWE
Noise level39 dB
Noise level (economic mode)34 dB
Multimedia
Built-in speaker(s)No
Design
Product colorGray
Product typeLarge venue projector
PlacementDesktop, Ceiling
Display
Built-in displayNo
Power
Power sourceAC
Power consumption (typical)670 W
Power consumption (standby)0.5 W
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Weight & dimensions
Width505 mm
Height194 mm
Depth385 mm
Weight16500 g
Packaging content
Handheld remote controlYes
Cables includedAC, VGA
Quick start guideYes
ManualYes
Warranty cardYes
Logistics data
Harmonized System (HS) code85286200
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the BenQ PW9520 below.

What is the weight of the BenQ PW9520?

The BenQ PW9520 has a weight of 16500 g.

What is the height of the BenQ PW9520?

The BenQ PW9520 has a height of 194 mm.

What is the width of the BenQ PW9520?

The BenQ PW9520 has a width of 505 mm.

What is the depth of the BenQ PW9520?

The BenQ PW9520 has a depth of 385 mm.

Is the manual of the BenQ PW9520 available in English?

Yes, the manual of the BenQ PW9520 is available in English .

Is your question not listed? Ask your question here

No results