BenQ PW9520 manual

BenQ PW9520
7.6 · 1
PDF manual
 · 75 pages
English
manualBenQ PW9520

English

16

Choosing a location

Your projector is designed to be installed in one of four possible installation locations.
Your room layout or personal preference will dictate which installation location you select. Take
into consideration the size and position of your screen, the location of a suitable power outlet, as
well as the location and distance between the projector and the rest of your equipment.
1. Front Table:
Select this location with the projector
placed near the oor in front of the screen.
This is the most common way to position
the projector for quick setup and portability.
2. Front Ceiling:
Select this location with the projector
suspended from the ceiling in front of the
screen. Purchase the BenQ Projector Ceiling
Mount Kit from your dealer to mount your
projector on the ceiling.
3. Rear Table:
Select this location with the projector
placed near the oor behind the screen.
Note that a special rear projection screen is
required.
70cm
4. Rear Ceiling:
Select this location with the projector
suspended from the ceiling behind the
screen. Note that a special rear projection
screen and the BenQ Projector Ceiling
Mount Kit are required for this installation
location.
70cm
* To set the projector position:
Press
MENU
and then press
/
until
INSTALLATION
menu is highlighted.
Press
/
to highlight
Projector Installation
and press
/
until the correct position is
selected.
Ceiling installation must be done by a qualied professional. Contact your dealer for more information. It is not
recommended you install the projector yourself.
Only use the projector on a solid, level surface. Serious injury and damage can occur if the projector is dropped.
Do not use the projector in an environment where extreme temperature occurs. The projector must be used at
temperatures between 41 degrees Fahrenheit (5 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).
Screen damage will occur if the projector is exposed to moisture, dust or smoke.
Do not cover the vents on the projector. Proper ventilation is required to dissipate heat. Damage to the projector
will occur if the vents are covered.

Manual

View the manual for the BenQ PW9520 here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 7.6. This manual is available in the following languages: English. Do you have a question about the BenQ PW9520 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the BenQ and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

BenQ PW9520 specifications

Below you will find the product specifications and the manual specifications of the BenQ PW9520.

General
BrandBenQ
ModelPW9520 | 9H.JDF77.26E
Productvideo projector
EAN0840046032326, 4718755057250
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness6000 ANSI lumens
Projection technologyDLP
Projector native resolutionWXGA (1280x720)
Screen size compatibility80 - 500 "
Native aspect ratio16:10
Projection distance- m
Contrast ratio (typical)2800:1
Number of colors1.073 billion colors
Keystone correction, horizontal-30 - 30 °
Keystone correction, vertical-30 - 30 °
Vertical scan range23 - 85 Hz
Horizontal scan range31 - 92 kHz
Matrix size0.7 "
Matrix type3-panel (p-Si TFT active)
Lens system
Zoom ratio1.3:1
Focal length range26 - 34 mm
Aperture range (F-F)1.64 - 1.86
Horizontal lens shift range-10 - 10 %
Vertical lens shift range0 - 50 %
Throw ratio1.81 - 2.38
Light source
Service life of light source2500 h
Service life of light source (economic mode)3000 h
Lamp power280 W
Light source typeLamp
Video
Analog signal format systemNTSC, PAL, SECAM
Full HDNo
3DNo
Supported graphics resolutions640 x 480 (VGA), 1920 x 1200 (WUXGA)
Ports & interfaces
VGA (D-Sub) ports quantity1
HDMI ports quantity1
USB 2.0 ports quantity1
Composite video in1
Component video (YPbPr/YCbCr) in0
HDMI version1.4
PC in (D-Sub)Yes
DVI portYes
Remote (IR) output2
S-Video inputs quantity1
12V triggerYes
Audio (L/R) in0
HDMI connector typeFull-size
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Ethernet LANYes
Wi-Fi-
Other features
RS-232 ports1
Storage
Card reader integratedNo
Features
HDCPYes
Preset modesGame, Presentation, Standard
On Screen Display (OSD)Yes
On Screen Display (OSD) languagesCHI (SIMPL), DEU, ENG, ESP, FRE, ITA, JPN, KOR, POR, RUS, SWE
Noise level39 dB
Noise level (economic mode)34 dB
Multimedia
Built-in speaker(s)No
Design
Product colorGray
Product typeLarge venue projector
PlacementDesktop, Ceiling
Display
Built-in displayNo
Power
Power sourceAC
Power consumption (typical)670 W
Power consumption (standby)0.5 W
AC input voltage220 - 240 V
AC input frequency50 - 60 Hz
Weight & dimensions
Width505 mm
Height194 mm
Depth385 mm
Weight16500 g
Packaging content
Handheld remote controlYes
Cables includedAC, VGA
Quick start guideYes
ManualYes
Warranty cardYes
Logistics data
Harmonized System (HS) code85286200
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the BenQ PW9520 below.

What is the weight of the BenQ PW9520?

The BenQ PW9520 has a weight of 16500 g.

What is the height of the BenQ PW9520?

The BenQ PW9520 has a height of 194 mm.

What is the width of the BenQ PW9520?

The BenQ PW9520 has a width of 505 mm.

What is the depth of the BenQ PW9520?

The BenQ PW9520 has a depth of 385 mm.

Is the manual of the BenQ PW9520 available in English?

Yes, the manual of the BenQ PW9520 is available in English .

Is your question not listed? Ask your question here

No results