Operation
34
• The input signal type effects the options a vailable fo r the Picture M ode.
See "Selecting a p icture mode" on pag e 36 fo r det ails.
F or best displa y pi cture r esult s, you should select and use an input signal
which outputs at this resolution. An y other resolutions will be scaled by
the projector depending upon the 'aspect ratio' setting, which ma y cause
some imag e distor tion or loss of picture clarity . See "Sel ecting the aspect
ratio" on pag e 35 for details.
Changing Color Space In the unlik ely ev ent that you connect the pr ojector to a D VD pla yer via the
pro jector's HDMI input and the pr ojected picture displa ys wrong colors, pl ease
change the color space to YUV .
1. Press MENU and then press / until the Source men u is highlighted.
2. Press to highlight Color Space Conversion and press / to selec t a
suitabl e color space .
This function i s only a vailable when the HDMI input port is in use.
Magnifying and searching for details If you ne ed to find the de tails on the pr ojected pictur e , magnify the picture. Use the
dire ction arr ow ke ys for na vigating the picture.
• Using the r emote control
1. Press ZOOM +/- to displa y the Zoom bar .
2. Press ZOOM + to magnify the center of
the picture. Press the k ey repeatedl y until
the picture size is suitable f or your need.
3. Use the dir ectional arr ows ( , , , )
on the proj ector or remote cont rol to
na vigate the picture.
4. T o restor e the picture to its original size,
press AUTO . Y ou can al so press ZOOM -
. When the k ey is pressed again, the pictur e
is further reduc e d until it is r estored to the original size.
•U s i n g t h e O S D m e n u
1. Press MENU and then press / until the DISPLAY menu is highlighted.
2. Press
to highlight Digital Zoom and press OK . The Z oom bar displays.
3. Repeat steps 2-4 in the section of "Usi ng the r emote contr ol" above. Or if y ou
are using t he pr ojector contr ol panel, continue to the foll owing steps.
4. Press on the pr ojector repeatedl y to magnify the picture to a desir ed size.
5. T o na vigate the picture, press OK to switch to the paning mode and pr ess the
directio nal arr ows ( , , , ) to na vigate the picture.
6. Use the dir ectional arr ows ( , , , ) on the projecto r or r emote control
to na vigate the pictur e.
Need help?
Do you have a question about the BenQ and is the answer not in the manual?
Question and answer
Number of questions: 0