Sets the projector ID for this projector (between 01~99). When multiple adjacent
projectors are in operation at the same time, switching the projector ID codes can
prevent interference from other remote controls. After the Projector ID is set,
switch to the same ID for the remote control to control this projector. See Remote
control on page 10
Set the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Enter the ID for the remote control (between 01~99). The remote control ID
should be the same as the corresponding projector ID.
3. The ID is saved successfully when you see the ID setting indicator starts
flickering and then blackout.
Clear the ID
1. Press and hold ID SET until the ID setting indicator lights up.
2. Press ALL to clear current ID setting of the remote control.
3. The ID is cleared successfully when you see the ID setting indicator starts
flickering and then blackout.
Reset Settings
Returns all of the adjustments you’ve made for the Settings menu to the factory
preset values.
LanguageSets the language for the On-Screen Display (OSD) menus.
Standby
Settings
• Network: Allows you to make following settings:
• Monitor Out: Allows the projector to output a VGA signal when it is in standby
mode and the PC IN jack and the MONITOR OUT jack are correctly
connected to devices.
• HDMI Out: Allows the projector to output an HDMI signal when it is in standby
mode and the HDMI 3 jack and the HDMI OUT jack are correctly connected to
devices.
• Audio Pass Through: The projector can play sound when it is in standby mode
and the corresponding jacks are correctly connected to devices. Press / to
choose the source that you wish to use. See Connection on page 20 for how to
make the connection.
Enable Network
Standby Mode
Allows the projector to provide the network function in
standby mode.
Switch to Normal
Standby Mode
Allows the projector to disable the network function
after a set period of time after it enters standby mode.
For instance, if 20 min is selected, the projector is able to
provide the network function for 20 minutes after it
enters standby mode. When 20 minutes is up, the
projector enters normal standby mode.
Manual
View the manual for the BenQ LU951ST here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.8. This manual is available in the following languages: English. Do you have a question about the BenQ LU951ST or do you need help? Ask your question here
Need help?
Do you have a question about the BenQ and is the answer not in the manual?
Question and answer
Number of questions: 0