2.To remove the insert: press the insert upwards from below with your
finger.
3.Clean the detergent dispenser tray and insert with water and a brush and
dry it.
4.Attach the insert and engage (connect the cylinder to the guide pin).
5.Push in the detergent drawer.
Leave the detergent drawer open so that any residual water can
evaporate.
Drum
Leave the washing machine door open so that the drum can dry out.
Rust stains - use chlorine-free cleaning agent, not steel wool.
Descaling Ensure there is no laundry in the machine
Descale the appliance according to the descaler manufacturer's instructions. This should not
be necessary if the correct dosage of detergent is used.
Information to indicator lights
Indicator lights for status displays and/or buttons flash:
Indicator lights
c(rinse)and
þü(wash)flash
Close the washing machine door properly; laundry may be caught.
Indicator lights
c(spin)and
þü(wash) flash
Open the tap completely, supply hose kinked or trapped;
Clean the filter a page 10, Water pressure too low.
Indicator lights
c(spin)and
c(rinse)flash
Detergent solution pump blocked; Clean the detergent solution pump
a page 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the
siphon a page 10.
Indicator light
c(rinse)flashes
Motor fault. Call the after-sales service.
All indicator lights flashTurn off the tap and call the after-sales service.
–Risk of electric shock.Disconnect the mains plug.
–Risk of explosion.No solvents.
10
Maintenance
Detergent solution pump
Turn the programme selector to stop (off) and disconnect the mains plug.
1.Open and remove the service flap.
2.For models with a drainage hose: Remove the drainage hose from the retainer and pull it
from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2*For models without a drainage hose: Carefully unscrew the pump cover until the
detergent solution begins to flow out. When the service flap is half full, close the pump cover
and empty the service flap. Repeat the above steps until all the detergent solution has
completely drained out.
3.Carefully unscrew the pump cover (residual water).
4.Clean the interior, pump cover thread and pump housing (the impeller in the detergent
solution pump must rotate).
5.Replace the pump cover and screw it in place tightly.
6.Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash: Pour 1 litre of water into
compartment II and start the 4 plus (empty) programme.
Drainage hose at the siphon
Turn the programme selector to stop (off) and disconnect the mains plug.
1.Loosen the hose clamp, carefully remove the drainage hose (residual water).
2.Clean the drainage hose and siphon connecting piece.
3.Reattach the drainage hose and secure the connection with the hose clamp.
Filter in the water supply
Reduce the water pressure in the supply hose:
1.Turn off the tap.
2.Select any programme (except for (spin), 4 plus (empty)).
3.Selectinicio (start). Let the programme run for approximately 40 seconds.
4.Turn the programme selector to stop (off). Disconnect the mains plug.
Clean the filter:
1.Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and Aqua-Secure models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
2.Connect the hose and check for leaks.
–Risk of scalding.
Allow the detergent solution to cool down.
–Turn off the tap.
11
What to do if...
ʑ
Water is leaking out.–Attach/replace the drainage hose correctly.
–Tighten the screw connection of the supply hose.
ʑ
No water supply. Detergent not dispensed.–inicio (start) not selected?–Tap not turned on?
–Filter blocked? Clean the filtera page 10.
–Supply hose kinked or trapped?
ʑ
Washing machine door cannot be opened.–Safety function active. Wait approx. 2 minutes.
–flot (no spin) (without final spin) selected? a page 3, 4.
ʑ
Programme does not start.–inicio (start) selected?
–Washing machine door closed?
ʑ
Detergent solution is not drained.
–flot (no spin) (without final spin) selected? a page 3, 4.
–Clean the detergent solution pump a page 10.
–Clean the waste pipe and/or drainage hose.
ʑ
Water not visible in the drum.–Not a fault - water below the visible area.
ʑ
Unsatisfactory spin result.Laundry wet/too damp.–Not a fault - the unbalanced-load detection system has cancelled the spin cycle because of uneven distribution of the laundry.Distribute small and large items of laundry evenly inside the drum.–Too low a speed selected? a page 5.
ʑ
Spin cycle performed several times.–Not a fault - unbalanced load detection system adjusts the imbalance.
ʑ
Residual water in the compartment for care products.–Not a fault - the action of the care product is not affected.–Clean the insert if necessary a page 9.
ʑ
Odour formation in the washing machine.
–Run programme resistentes/algod. (cottons) 90 °C without laundry. Use
standard detergent.
ʑ
Foam escaping from the detergent drawer.–Too much detergent used?If foam is escaping from the detergent drawer:Mix 1 tablespoon of fabric softener with ½ litre of water and pour into compartment II (not with outdoor or down fabrics).–Reduce the detergent dosage for the next wash cycle.
ʑ
Intense noise formation, vibrations and “walking” during the spin cycle.–Are the appliance feet fixed?Secure the appliance feet a Installation instructions.–Transportation safety devices removed?Remove the transportation safety devices a Installation instructions.
ʑ
Noises during spin and drain cycles.
–Clean detergent-solution pump apage 10
ʑ
The indicator lights do not function during operation.–Power cut?–Fuses tripped? Reset/change the fuse.–If the fault occurs repeatedly, call the after-sales service.
ʑ
Programme sequence longer than usual.–Not a fault - unbalanced load detection system adjusts imbalance by repeatedly distributing the laundry.–Not a fault - foam detection system active - adds an additional rinse cycle.
ʑ
Detergent residues on the laundry.–Occasionally, phosphate-free detergents contain water-insoluble residues.
–Select 5 plus (rinse) or brush out the laundry after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
–Turn the programme selector to stop (off) and remove the mains plug from the socket.
–Turn off the water supply and call the after-sales service a Installation instructions.
Instruction manual
en
Washing
machine
Observe the safety instructions on page 8!
Read these instructions and the separate
installation instructions before operating
the washing machine.
View the manual for the Balay 3TS70105T here, for free. This manual comes under the category washing machines and has been rated by 21 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Balay 3TS70105T or do you need help? Ask your question here
Need help?
Do you have a question about the Balay and is the answer not in the manual?
Receive updates on solutions
Get answers to your question
Question and answer
Number of questions: 15
I
Isabel November 17, 2021
What is the shortest program on the Balay 3TS70105T washing machine?
View photoThis message has been automatically translated
The Balay 3TS70105T is a freestanding washing machine with a maximum rated capacity of 7 kg. It has an energy consumption of 1.19 kWh per cycle and a power consumption of 2300 W (typical). The machine consumes 49 L of water per cycle and has a maximum cycle time of 155 minutes. Its washing class is A and its spin-drying class is C, with a maximum spin speed of 1000 RPM. The machine features a foam control system to ensure a smooth wash. The door hinge is positioned on the left and the cord length is 1.6 meters.
This washing machine is designed to handle a moderate load of laundry and comes equipped with customizable settings for optimal washing performance. It has a sleek, modern design, with a durable construction built to last for years. Its energy consumption is relatively average, with a typical power consumption for its class of washing machines. The Balay 3TS70105T is a functional appliance with a strong focus on eco-friendliness, making it a great choice for those who want to minimize their environmental impact.
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Balay 3TS70105T below.
What temperature should I use for my laundry?
The washing label of your garment shows the recommended washing temperature.
Do I need to use an anti-scaling agent for my washing machine?
It is not necessary to use an anti-scaling agent. Scale deposits can be prevented by limiting washing at high temperatures and using the recommended amount of detergent per wash.
How do I prevent my washing machine from smelling?
Unpleasant odours can be avoided by occasionally washing at 60 degrees and using the recommended amount of detergent per wash.
What is the height of the Balay 3TS70105T?
The Balay 3TS70105T has a height of 848 mm.
What is the width of the Balay 3TS70105T?
The Balay 3TS70105T has a width of 600 mm.
What is the depth of the Balay 3TS70105T?
The Balay 3TS70105T has a depth of 590 mm.
Why is my washing machine not starting?
First, ensure that the power cord is securely plugged into an electrical outlet. Check if the circuit breaker has tripped or if there is a power outage. Additionally, make sure the door is fully closed and the water supply is turned on.
How can I select the appropriate wash cycle for my laundry?
Familiarize yourself with the different wash cycles available on your Balay 3TS70105T washing machine. Consider factors such as fabric type, level of soiling, and desired water temperature. Choose the cycle that best matches your laundry's requirements using the control panel.
What should I do if there is water leakage during operation?
Check if the water inlet hose and drain hose are properly connected and tightened. Inspect the connecting points for any signs of damage or blockage. Ensure that the detergent drawer is not overfilled and that the door seal is clean and intact. If the issue persists, seek professional assistance.
How can I prevent excessive vibration during the spin cycle?
Verify that the washing machine is placed on a level surface, as uneven flooring can cause excessive vibration. Ensure that the load inside the machine is balanced properly, with similar items distributed evenly. If needed, adjust the adjustable feet of the machine to stabilize it further.
Why is the washing machine not draining water at the end of the cycle?
Check if the drain hose is kinked or blocked. Clear any potential obstructions and ensure the hose is properly connected to a drainage system or an external pump if required. Verify that the water pump filter is clean and free from debris. If problems persist, contact a professional technician for assistance.
Does the Balay 3TS70105T have a foam control system?
Yes, the Balay 3TS70105T has a foam control system. This means that the washing machine is designed to detect and prevent excessive foam during the washing process, ensuring optimal cleaning results.
Is the Balay 3TS70105T a freestanding washing machine?
Yes, the Balay 3TS70105T is a freestanding washing machine. This means that it can be placed anywhere in your home without the need for additional support or installation.
What is the maximum spin speed of the Balay 3TS70105T?
The maximum spin speed of the Balay 3TS70105T is 1000 RPM. This means that it can effectively extract water from your laundry, reducing drying time and energy consumption.
Does the Balay 3TS70105T have a load balancing system?
Yes, the Balay 3TS70105T has a load balancing system. This means that it can distribute the weight of the laundry evenly in the drum, minimizing vibration and noise during the washing process.
What is the rated capacity of the Balay 3TS70105T?
The rated capacity of the Balay 3TS70105T is 7 kg. This means that it can accommodate up to 7 kilograms of laundry in a single wash cycle, making it suitable for medium-sized households.
Is the manual of the Balay 3TS70105T available in English?
Yes, the manual of the Balay 3TS70105T is available in English .
Need help?
Do you have a question about the Balay and is the answer not in the manual?
Question and answer
Number of questions: 15What is the shortest program on the Balay 3TS70105T washing machine?
How do you do a short wash cycle?
This message has been automatically translatedWhat is the best cycle for washing clothes
How do I dry my clothes
How do you put a quick wash on the Ballay 7g 1000?
how do I fine the quick wash cycle on my balay washing machine
What is the shortest program on my baby washing machine
We are unable to open the door after a load of laundry was done
How do I set a short wash cycle?