B-Tech BT7333 manual

B-Tech BT7333
7.9 · 1
PDF manual
 · 5 pages
manualB-Tech BT7333





v.1208 OR1BX PAGE 1 / 5This pack contains:1 desk stand kit
Caution: Do not exceed the maximum weight limit indicated for this product.
Failure to comply may cause instability and possible serious injury.
©Copyright 2008.
Asia PacificB-Tech International (Hong Kong) Ltd.23rd Floor, Manulife Tower, North Point, HKTel: (+852) 2556 7337 Fax: (+852) 2556 7321Email: info@btechavmounts.com.hkEuropeB-Tech PRO-AV bvbaBrixtonlaan 32, Zaventem 1930,Brussels, BelgiumTel: +32 (0)2 720 92 71 Fax: +32 (0)2 725 42 15Email: info@btechproav.comNorth AmericaB-Tech Audio Video Mounts.10 Greg Street, #108, Sparks, NV 89431, USATel: (1)800 975 5812 Fax: (1)800 592 2876Email: info@btechavmounts.comHead OfficeB-Tech International Ltd.Bennett House, Long March, Daventry, Northants NN11 4NR, UKTel: +44 (0)1327 300 787 Fax: +44 (0)1327 706 562Email: info@btechavmounts.co.uk
300 mm (11.8")
Designed to mount 3 flat screen monitors up to 22" (widescreen) onto a desk The glass base is designed to hold a keyboard on top when not in use to keep the workspace tidy The position of the flat screens can be adjusted along the horizontal bar 510 – 1110mm (20” – 43.7”) Suitable for flat screens with the following VESA fixings: 100 100mm, 75 x 75mm and 50 x 50mm Maximum load: 45Kg (99lbs), 15Kg (33lbs) per interface mount AViBall adjusts 37° in any direction, centre interface tilts -10°/+25° Pole dimensions: Ø50mm (2”), 0.4M (15.7”) length Base dimensions: W 500mm (19.7”), D 300mm (11.8”), H 20.5 (0.8”) Base made from 10mm (0.4”) thick tempered safety glass with non-slip rubber feet Cable management and pole end ring included All fixings included Made in ChinaThis desk mount is intended for use only with the maximumweights indicated. Use with heavier than the maximumindicated may result in instability causing possible injury.
1206 mm (47.5")
ADJUSTMENT 510 - mm (20" - 43.7")
mm (16.8")
115 mm (4.5")
54 mm (2.1")
500 mm (19.7")
mm (3.8")
64,5 mm (2.5")
or 98 mm (3.8")

Important Safety Instructions.

Read first

Do not attempt to install this product until all instructions and warnings have been read and

properly understood. Please keep these instructions for future reference.

B-Tech International Limited, its distributors and dealers are not liable or responsible for

damage or injury caused by improper installation, improper use or failure to observe these

safety instructions. In such cases, all guarantees will expire.


B-Tech International Ltd recommends that a professional AV installer or other suitably qualified

person install this product. Great care must always be taken during installation as most AV

equipment is of a fragile nature, possibly heavy and easily damaged if dropped.

If you do not fully understand the instructions or are not sure how to install this product safely,

then please consult a professional for advice and/or to install this product for you. Failure to

mount this product correctly may cause serious injury or death both during installation and at

any time thereafter.

Do not mount any AV equipment that exceeds the specific weight limit of the product you are

installing. This weight limit will be clearly stated on each product and its packaging and will

vary from product to product.

Product location

Please pay careful attention to where this product is located.

Fixing hardware

It is highly recommended that all fixing screws be used where supplied and that the purpose of

all other fixing hardware is fully understood. In some cases more AV equipment fixing

hardware will be supplied to accommodate different models of equipment and set up


The installer must be satisfied that any supplied fixing hardware is suitable for each specific

installation. If any fixing screws or included hardware are deemed not sufficient for a safe

installation then please consult a professional or your local hardware store.

Hazard limitation

When routing cables take advantage of any built in cable management features that the

product might provide and ensure that all cables are tidy and secure. Check to see that any

moving aspect of the product can do so unhindered by any cabling.

Some products have moving parts and the potential to cause injury through the crushing or

trapping of fingers or other body parts.

Particular attention to the nature of moving parts is required especially when assembling

installing and adjusting during set up.

Immediately after installations double-check that the work done is safe and secure. Double-

check all necessary fixings are present and are of ample tightness.

It is recommended that periodic inspections of the product and its fixing points are made as

frequently as possible to ensure that safety is maintained. If in doubt consult a professional AV

installer or other suitably qualified person.

View the manual for the B-Tech BT7333 here, for free. This manual comes under the category Flat panel support and has been rated by 1 people with an average of a 7.9. This manual is available in the following languages: English. Do you have a question about the B-Tech BT7333 or do you need help? Ask your question here

Need help?

Do you have a question about the B-Tech and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other B-Tech owners to provide you with a good answer.

Number of questions: 0

Gas piston design allows 130mm of smooth, precise height adjustment so your display is always in the most comfortable po...
BT7333 | BT7333/B
Flat panel support
User manual (PDF)
Maximum screen size22 "
Maximum weight capacity45 kg
Minimum VESA mount75 x 75 mm
Maximum VESA mount100 x 100 mm
Number of displays supported3
Minimum screen size- "
Mounting typeDesk
Tilt angle range-37 - 37 °
Swivel angle range-37 - 37 °
Cable management
Height adjustment
Product colourBlack
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the B-Tech BT7333 below.

Is your question not listed? Ask your question here

No results