Azden WHD-PRO + I manual

Azden WHD-PRO + I
(1)
  • Number of pages: 4
  • Filetype: PDF
WHD-PRO + i AUDIO KIT
WR-PRO - WM-PRO - EX-503 - SGM-990 - HX-i CABLE

INSTRUCTION MANUAL

WARNING
Do not store or use the products in high heat or humidity.
Do not use near a broadcast staon, airport or plane. You must change the frequencies if you are
interfering with other transmiers.
The system will work connuously for 10 hours on one set of baeries. If sound quality is poor,
change baeries.
Remove baeries when the system is not in use.
Thank you for purchasing the AZDEN WHD-PRO Audio Kit. The following contents are included in your kit:
1 x WR-PRO VHF Receiver
1 x WM-PRO VHF Belt-Pack Transmier
1 x EX-503 Lavalier Microphone
1 x SGM-990 Direconal Microphone
1 x HX-i Smartphone Connector Cable
The PRO systems operate in the low-interference VHF band and have 2 switchable frequencies,
169.445 (F1) and 170.245 (F2). You should select the quieter frequency for use.
The systems conforms to Part 90 of the FCC rules. You should contact the FCC oce for ling forms.
1. Loading Baery
Open the baery compartment lid by sliding it down and raising the lid. Insert a 9-volt
baery into the baery compartment with the correct polarity. Direcons are on the inside of the
baery compartment. Do not force the baery compartment lid to close. If it does not close easily,
turn the baery around and try again.
2. Power/Frequency Selector Switch
This slide switch is used to turn the unit on and o as well as to select a frequency. When
not using the WR-PRO, make sure that the switch is turned to OFF.
3. Signal Indicator
This LED has 2 funcons: When you rst turn the Power/Frequency Selector Switch of the
Receiver on, but if the Transmier is not on, the LED will show red indicang that the baery is good.
If both the Transmier and the Receiver are on and they are on the same frequency, the Receiver LED
will show green and the Transmier LED will show red.
WR-PRO RECEIVER
Azden WHD-PRO + I

Need help?

Number of questions: 0

Do you have a question about the Azden WHD-PRO + I or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Azden WHD-PRO + I owners to properly answer your question.

View the manual for the Azden WHD-PRO + I here, for free. This manual comes under the category Wireless Microphone Systems and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Azden WHD-PRO + I or do you need help? Ask your question here

Azden WHD-PRO + I specifications

General
Brand Azden
Model WHD-PRO + I
Product Wireless microphone system
Language English
Filetype PDF
Packaging content
Number of microphones included 1
Number of receivers included 1
Number of transmitters included 1
Microphone
Microphone type Handheld microphone
Receiver
Receiver type Camera mount receiver
Transmitter
Transmitter type Bodypack transmitter
Features
Operating frequency type Very High Frequency (VHF)
Number of transmission frequencies 2
Number of receiving frequencies 2
Operating frequency 169.445, 170.245 MHz
Microphone frequency response 150 - 18000 Hz
Signal-to-Noise Ratio (SNR) 40 dB
Weight & dimensions
Receiver dimensions (W x D x H) 60 x 21.5 x 86 mm
Receiver weight 128 g
show more

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Azden WHD-PRO + I.

Is your question not listed? Ask your question here