2Power (Terminal block)The power adapter wires (+9V and GND) plug in
here.
See How to Supply Power, page 9 for the steps
on how to connect the terminal block to a power
source.
3Power Port (VE157)
DDC Port (VE607 / VE807)
Use a Cat 5e cable to connect the Transmitter
and Receiver units through this port.
The second Cat 5e cable connection transmits the
power signal to either the Transmitter or Receiver
when only one of the units is supplied power via
the Terminal Block.
For VE607 / VE807, in addition to transmitting the
power signal, the second Cat 5e cable is used for
real EDID Bypass and HDCP key authentication.
4Grounding TerminalThe grounding wire is attached here.
Note: The grounding wire is not included in this
package.
1
2
3
4
Manual
View the manual for the ATen VE807 here, for free. This manual comes under the category AV extenders and has been rated by 1 people with an average of a 6. This manual is available in the following languages: English. Do you have a question about the ATen VE807 or do you need help? Ask your question here
Need help?
Do you have a question about the ATen and is the answer not in the manual?
Question and answer
Number of questions: 0