Name: Ashly RPS-18
Brand: Ashly
SKU: 1700545
Rating: 97 (1 reviews)

manualAshly RPS-18

Ashly WR-5 Remote Control

1. Introduction

The WR-5 is a microprocessor based serial data remote control

unit for Ashly NE or NX products. Compatible products currently

include Pema ampliers, ne8800 and ne4800 system processors,

the ne24.24M matrix processor, all models of the NE multichannel

power ampliers, and nXe/nXp ampliers. Using Protea

software,

six function select buttons and two parameter adjust buttons are

available to control a limited range of assigned functions within

their host product. Up to four WR-5 units can be daisy-chained and

phantom powered from one host, and even more can be added using

an in-line power supply adapter such as the Ashly RPS-18. Note:

When an WR-5 is connected to an Ashly product, no other serial

communications devices, including the Ashly RD-8C remote fader

controller, may be used with that product.

The WR-5 is designed to t into a standard US electrical wall

box. Electrical connections to the host unit are made using a four

conductor low gauge wire terminated with Euroblock connectors.

There is also a two pin jumper labeled “J6” which requires the

provided female jumper to be installed in specic situations (see

section 2). Note: The WR-5E is the electrical equivalent to the WR-

5, but designed to t into a UK electrical box. A standard decora

plate (not included) can be purchased separately to cover the WR-5

electrical box and satisfy the aesthetic needs of the installation.

Note: Avoid static shock disruptions by mounting the WR-5 to an

earth-grounded metal wall box, or by earth-grounding the metal

cover plate. This prevents potential static discharge from owing

back through the data wires to the host device.

Each of six buttons on the WR-5 can be programmed through

Protea

Software to engage one of the following functions (if

available): preset recall, preset scroll, gain control, channel

engage/mute, zone source selection, logic output active high,

logic output active low, and matrix mixer, with a green LED

next to each button to display active status.

To the right of the ve programmable buttons is a pocket in

the mylar overlay for a paper function label to be inserted. See

section 6 for a blank template which can be copied, or get an

editable label template from the Ashly website. The two other

buttons are used to adjust function parameters, indicated by the

LED character display.

WR-5 Front View with Label

WR-5 Rear View

WR-5 Wall-Box Assembly

Ashly Audio Inc.

847 Holt Road Webster, NY 14580-9103 Phone: (585) 872-0010

Toll-Free: (800) 828-6308 Fax: (585) 872-0739 ashly.com

View the manual for the Ashly RPS-18 here, for free. This manual comes under the category Not categorized and has been rated by 1 people with an average of a 9.7. This manual is available in the following languages: English. Do you have a question about the Ashly RPS-18 or do you need help? Ask your question here

Need help?

Do you have a question about the Ashly and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Ashly owners to provide you with a good answer.

Number of questions: 0