Arctic AS5 manual

Arctic AS5
(1)
  • Number of pages: 2
  • Filetype: PDF
  • Arctic Silver Incorporated MSDS # AS5_3

    Page 1 of 2

    SECTION 1: CHEMICAL PRODUCT AND COMPANY INFORMATION
    Company Address:
    9826 W. Legacy Ave.
    Visalia, CA 93291
    Product Information: 559-740-0912
    Medical Emergency Toll Free: 877-740-5015 Prepared by: Nevin House
    Medical Emergency Alternate: 303-739-1110 Revision Date: January 25, 2011
    Product Identification
    Arctic Silver 5 High-Density Polysynthetic Silver Thermal Compound
    Product Code: AS5
    SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
    Product Ingredient Information CAS No.
    Silver (Metallic) 7440-22-4
    Boron Nitride 10043-11-5
    Zinc Oxide 1314-13-2
    Aluminum Oxide 1344-28-1
    Ester Oil Blend Non-hazardous
    SECTION 3: HAZARD IDENTIFICATION
    Emergency Overview: Grey grease. This product is nonflammable. Liquid will irritate eyes.
    Potential Health Effects:
    Eyes:
    This product is an eye and mucus membrane irritant.
    Skin:
    Not expected to be a skin irritant. Repeated and prolonged skin contact could cause minor skin irritation.
    Ingestion:
    Silver ingestion may result in generalized argyria.
    Inhalation: No specific information available.
    Pre-Existing Medical Conditions Aggravated by Exposure
    : eye
    SECTION 4: FIRST AID MEASURES
    Eyes:
    Immediately flush with large amounts of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Have eyes
    examined by a Physician.
    Skin:
    Remove contaminated clothing and wash skin with soap and water. Get medical attention if irritation develops/persists. Wash clothes separately before reuse.
    Ingestion:
    If appreciable quantities are swallowed, seek medical advice.
    Inhalation:
    Not likely route of exposure. If inhaled and irritation occurs, remove to fresh air. If irritation persists, call a Physician.
    SECTION 5: FIRE FIGHTING MEASURES
    Flash Point
    : > 600F (Setaflash) LEL/UEL: NA (% by volume in air)
    Extinguishing Media:
    Use carbon dioxide or dry chemicals for small fires, aqueous foam or water for large fires involving this material.
    Fire Fighting Instructions:
    Remove all ignition sources. Closed containers may rupture due to build-up of pressure when exposed to extreme heat. Fight fire from a
    safe distance. As in any fire, wear self-contained breathing apparatus (pressure demand, OSHA/NIOSH approved or equivalent) and full protective gear.
    SECTION 6: ACCIDENTAL RELEASE MEASURES
    Large Spills:
    Remove all sources of ignition (sparks, open flames, etc.). Wear self-contained breathing apparatus and appropriate personal protective equipment.
    Ventilate area and contain spill with sand or other absorbent material. Collect spill by scooping up liquids and absorbent material and place in a sealed metal container
    for proper disposal. Do not flush to sewer. Prevent material from entering storm sewers, ditches that lead to waterways and ground.
    Small Spills:
    Absorb spill with absorbent material, then place in a sealed metal container for proper disposal.
    SECTION 7: HANDLING AND STORAGE
    Overheating may cause container to rupture. Use explosion proof electrical equipment. Containers must be kept closed and ventilation provided to prevent vapor
    concentration build-up. Store in a cool dry place. Do not breathe vapor or get liquid in eyes, or on skin and clothing. Keep away from heat or sources of ignition.
    Check all containers for leaks. Wear protective clothing as in section above. Avoid prolonged breathing of vapors or contact with skin. Ensure that all equipment is
    grounded to prevent static discharge. Containers of this material may be hazardous when emptied due to solid or vapor residue. All hazard precautions given in this
    data sheet must be observed for empty containers.
    KEEP OUT OF REACH OF CHILDREN.
    SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
    Exposure Guidelines:
    CHEMICAL NAME ACGIH TLV OSHA PEL ACGIH STEL
    Silver 0.1 mg/m3 0.01mg/m3 NA
    Boron Nitride 10 mg/m3 10 mg/m3 NA
    Zinc Oxide 10 mg/m3 (dust) 15 mg/m3 (dust) 10 mg/m3
    Aluminum Oxide 10 mg/m3 (dust) 10 mg/m3 (dust) NA
    Polyol Ester NA NA NA
    NFPA and HMIS Codes:
    NFPA HMIS
    Health 1 1
    Flammability 1 1
    Reactivity 0 0
    Personal Protection - B
    SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
    Physical State:
    Grey Grease Solubility in Water: <1.0%
    Odor
    : None Specific Gravity: 4.05-4.15
    pH:
    NA Evaporation Rate: Slower
    Vapor Pressure:
    NA (Butyl acetate=1)
    (Air 1) Boiling Range:
    NA
    Vapor Density:
    NA (Water =1)
Arctic AS5

Need help?

Number of questions: 0

Do you have a question about the Arctic AS5 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Arctic AS5 owners to properly answer your question.

View the manual for the Arctic AS5 here, for free. This manual comes under the category Not categorized and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Arctic AS5 or do you need help? Ask your question here

Arctic AS5 specifications

General
Brand Arctic
Model AS5
Product Not categorized
EAN 0642008439903, 0794057451358, 0798804167585, 0800953173550, 0801579489704, 0840556003052, 0979980001317, 4054842428276, 4139052006664, 5053086002678, 5053688998935, 5053973984537, 5054484398295, 5054629283417, 5147841727866, 5147841727880, 5711045836251, 6003770001813, 7123290430722, 7337331954249, 7387809023106, 7755774225861, 840556003052, 8536692507807
Language English
Filetype PDF
Weight & dimensions
Weight 3.5 g
Features
Operating temperature (T-T) -50 - 130 °C
Thermal conductivity 9 W/m·K
Product colour Black,Grey