Allied Telesis AT-SBX81XS6 manual

Allied Telesis AT-SBX81XS6
8.6 · 1
PDF manual
 · 314 pages
English
manualAllied Telesis AT-SBX81XS6
Chapter 15: Building a Stack
276 Section III: Building a Stack with VCStack Plus

Before You Begin

Please note the following before you begin to configure the switches for
stacking:
You must perform the procedures in the order presented here.
You should configure only one chassis at a time.
The procedures are the same regardless of whether a chassis has
one or two controller cards.
Note
This procedure requires power cycling or resetting the switches.
Some network traffic may be lost if the units are already connected
to an active network.
The procedures assume the following:
All hardware components have been installed in the two switches,
including Ethernet line cards, controller cards, and power supplies.
For installation instructions, refer to the previous chapters in this
guide.
The switches are powered on. For instructions, refer to Chapter 9,
“Powering On the Chassis” on page 163.
You verified the operations of the chassis with the procedures in
Chapter 10, “Verifying the Hardware Operations of the Chassis” on
page 201.
There are no transceivers in the SFP+ slots on the AT-
SBx81CFC960 Controller Fabric Cards. If there are transceivers in
the slots, you should remove them before performing the
procedure.
A stack requires these additional items:
Two VCStack Plus feature licenses: Each chassis must have its
own license. For more information, refer to “VCStack Plus Feature
License” on page 268.
Eight AT-Stack transceivers if each switch in the stack has one
controller card and sixteen transceivers if each switch has two
controller cards. The transceivers form the trunk that connects the
two switches together. For more information, refer to “Stack Trunk
and Stacking Transceivers” on page 263.

Manual

View the manual for the Allied Telesis AT-SBX81XS6 here, for free. This manual comes under the category not categorized and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Allied Telesis AT-SBX81XS6 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Allied Telesis and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Allied Telesis AT-SBX81XS6 specifications

Below you will find the product specifications and the manual specifications of the Allied Telesis AT-SBX81XS6.

General
BrandAllied Telesis
ModelAT-SBX81XS6 | AT-SBX81XS6
Productnot categorized
EAN0767035195957, 767035195957, 7670351959574
LanguageEnglish
FiletypeUser manual (PDF)
Optical fiber
Fiber optic connectorSFP+
Data transmission
Data transfer rate10 Gbit/s
Ports & interfaces
Fiber ports quantity6
Performance
Compatibilityx8100
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Allied Telesis AT-SBX81XS6 below.

Is the manual of the Allied Telesis AT-SBX81XS6 available in English?

Yes, the manual of the Allied Telesis AT-SBX81XS6 is available in English .

Is your question not listed? Ask your question here

No results