11
CONTENTS INTR ODUCTION INST ALLA TIONOPERA TION
FUR THER
INFORMA TION
Operation Power and activity indicators Eachmodulepr ovidestwoindicatorstoconrmpo werstatusandalsofeedbackabout
the various input signals:
GENERAL USE In use, the X-D VIPR O and X-D VIPR O-MS2 modules should be transparent - the system
and its peripherals should operate exactly as normal, the only diff erence being that the y
are no w up to 50 meters apart.
Video display (EDID) information ExtendedDispla yIdenticationData(orEDID)isanindustr ystandardschemewhich
allows video displa ys to declare their capabilities to the computer’ s video adapter
circuitry , allowing the latter to optimize their outputs accor dingly . Since the widespread
adoption of the scheme, video adapters ha ve become incr easingly dependent on receiving
rele vant EDID information during start-up, befor e they will output an ything more than a
rudimentar y video signal.
Each time that the remote module is po wer ed on, it attempts to read the EDID
information fr om the connected D VI video monitor . If the attempt is successful, the
information is transfer red to the local module and stor ed within non-volatile memory .
This information is then made a vailable to the computer’ s video adapter when requir ed.
On MS2 variants, EDID is handled independently for the tw o video connections, allowing
completelydiffer entvideodispla ycongurationsonthetwoports.
HDMI 1.3a operation Using optional HDMI to D VI converter cables (Adder part number : VSCD11), the
AdderLink X-D VIPR O-MS can suppor t HDMI video and audio up to the 165MHz clock
rate (1920 x 1080 at 60Hz, 24-bit color).
Eight channels of HDMI audio are supported with sample sizes of 16, 20 or 24-bits at
32KHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, or192kHz(simultaneouslywiththe
jack audio).
Note: The High-bandwidth Digital Content Pr otection (HDCP) and Consumer Electronics Contr ol
(CEC) schemes are not suppor ted.
Local module
Green:
•Onwhenpow erispresent.
Y ello w:
•OnwhenavalidD VIvideoinputsignalisbeingreceived
from the computer .
• OffwhentheC A Txlinkcableisdisconnected.
Note: On MS2 variants , the link por ts are independent, so failur e
of one link does not affect the video or USB status of the other
link.
Remote module
Green:
•Onwhenpow erispresent.
Y ello w:
•OnwhenavalidD VIvideoinputsignalisbeingreceived
from the local module.
Flashes regularl y (twice per second) when no valid D VI
video signal is being receiv ed from the local module.
Note: On MS2 variants , the link por ts are independent, so failur e
of one link does not affect the video or USB status of the other
link.
HT
Need help?
Do you have a question about the Adder and is the answer not in the manual?
Question and answer
Number of questions: 0