Abus MK4100 manual

Abus MK4100
6.6 · 1
PDF manual
 · 6 pages
English
manualAbus MK4100

UK

MK4100

Installation instructions Magnetic contact for gates and doors

Introduction

Top-class, heavy-duty contact for gates and doors. Extremely robust aluminium design highly-resistant to breakages (e.g.
when driven over by forklifts). VdS Class C certified.

Advantages of the magnetic contacts

High resistance to environmental conditions
Very large switching intervals
Extremely high resistance to wear
Simple installation

Installation

Installation is primarily made on roll-up, sliding and tilting gates and doors.
Before installation, determine the installation location so that the door contact and magnet can be fitted as shown in fig. 2.
The contact casing is fitted on the floor (a flat mounting surface is necessary).
Otherwise, only screws made of non-ferromagnetic materials may be used.
The weatherproof and mechanically stable construction of the contact casing protects the switching mechanism from
damage when driven over by vehicles with rubber tyres. To protect the product from greater loads, it must be embedded
into the ground.
The four-core cable is protected by a stainless steel protective sleeve. Two hose clips with screws and wall plugs are
included in the installation set for laying the metal sleeve properly away from the door or gate area.
When fitting the magnet casing, note the position of the two screw-holes on the contact casing, as shown in fig. 1. These
two holes determine the exact lateral position of the magnet relative to the contact.
The spacing between the contact casing and magnet casing should measure approximately 5-25 mm (as shown in the
diagram). If ferromagnetic materials are present in the immediate vicinity, then the switching areas must be specially
determined. The magnet should always be fitted in the middle of the non-operational area whilst adhering to VdS fitting
guidelines.
During installation, pay attention to the movement tolerance of the movable fitting surface for the magnet casing.
After installation is completed, the electrical functions on the contact must be checked (e.g. ohmmeter or circuit tester).

Warning:

The magnet loses some of its field strength if exposed to intense
heat or vibrations. This can also happen if it is placed near another
magnet and like poles are placed together.

Technical data:

Housing material: Aluminium
Cable: 2 m (double-insulated: 4 x 0.14 mm²)
Connections: NC, max. contact capacity
60 V DC / 300 mA / 3 W
Temperature with fixed cables: -25 °C to +70 °C
Temperature with movable cables: -5 °C to +50 °C
Protection class: IP 65
Optimal spacing between sensors: 5-25 mm
VdS Class B: G 198067

Functional diagram

Floor
Magnet switch
Fig. 2
Fig. 1
aproxx. 20 mm
Door
Magnet switch

Manual

View the manual for the Abus MK4100 here, for free. This manual comes under the category door / window sensors and has been rated by 1 people with an average of a 6.6. This manual is available in the following languages: English. Do you have a question about the Abus MK4100 or do you need help? Ask your question here

Need help?

Do you have a question about the Abus and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Abus MK4100 specifications

Below you will find the product specifications and the manual specifications of the Abus MK4100.

General
BrandAbus
ModelMK4100 | MK4100
Productdoor / window sensor
LanguageEnglish
FiletypeUser manual (PDF)
Features
Product colorAluminum
Housing materialAluminum
CertificationVdS C
Connectivity technologyWired
Ambient temperature (max)55 °C
Interface-
Power
Power supply input voltage60 V
Weight & dimensions
Width180 mm
Height14 mm
Depth45 mm
Packaging content
Number of products included1 pc(s)
Technical details
Product colorAluminum
Housing materialAluminum
CertificationVdS C
Power supply input voltage60 V
Width180 mm
Height14 mm
Depth45 mm
Interface-
Number of products included1 pc(s)
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Abus MK4100 below.

What certifications does the Abus MK4100 have?

The Abus MK4100 has the following certifications: VdS C.

What is the height of the Abus MK4100?

The Abus MK4100 has a height of 14 mm.

What is the width of the Abus MK4100?

The Abus MK4100 has a width of 180 mm.

What is the depth of the Abus MK4100?

The Abus MK4100 has a depth of 45 mm.

Is the manual of the Abus MK4100 available in English?

Yes, the manual of the Abus MK4100 is available in English .

Is your question not listed? Ask your question here

No results